InFocus 330 manual Turning Off the Projector

Page 22

S e t t i n g	u p	t h e	P r o j e c t o r

NOTE: Lamp life will be extended if you turn the lamp off, then wait 1 minute while the lamp cools before unplugging the projector. The Lamp LED will light green when the lamp has cooled. See page 16 for details on the Lamp LED.

Turning Off the Projector

If you want to turn off the projector for a short period of time, press the standby button on the keypad or remote. This blanks the screen for fifteen minutes, but keeps the projector running. (You can change the amount of time the projector stays in standby mode; see “Standby Time” on page 23 for details.) After 15 min- utes, the lamp goes out (the projector keeps running). To exit standby mode, press the standby button again. (It may take sev- eral seconds for the projection lamp to reach full power and project the image again.)

To completely power off the projector, unplug it. If you want to turn the lamp back on immediately, you must allow about a minute for the lamp to cool. The lamp won’t light if it’s too hot.

12

Image 22

Contents I D E Page Safety Certifications Declaration of Conformity Table of Contents Appendix IndexSafety Instructions F e t y S t r u c t i o n s T R O D U C T I O N Compatibility Image ResolutionIntroduction Unpacking the ProjectorT r o d u c t i o n Usage Guidelines Warranty If You Need AssistanceSetting UP Projector Setting UP the Projector T t i n g O j e c t o r Connecting a Computer T t i n g O j e c t o r Connecting a Video Player Audio Adapter Composite video cable Audio cableCable Powering up the Projector and Adjusting the Image Turning Off the Projector Using Projector Basic Image Adjustment Using the ProjectorUsing the Remote Control I n g O j e c t o r Adjusting the Projector Using the Keypad and Remote Buttons Standby Using the On-Screen Menus Display Menu Audio Menu Image Menu I n g O j e c t o r Position and Vert. Position Controls Menu Rear Projection Language Menu Status Menu I N T E N a N C E Troubleshooting Cleaning the Lens Maintenance & TroubleshootingReplacing the Projection Lamp Pull the lamp door up and remove it Lift and grasp the pull tab and lift the module out Figure Replacing the Batteries in the Remote Control Using the Kensington LockProblem The screen resolution is not right Troubleshooting Problem Nothing on projection screenProblem Color or text not being projected Problem Image isn’t centered on the screenProblem Image is too wide or narrow for screen Problem no sound Problem Image is out of focusProblem Image and menus are reversed left to right Problem Image is noisy or streakedProblem Lamp seems to be getting dimmer Problem Lamp shuts offP E N D I Specifications AppendixAccessories Standard Accessories Ship with the projector Part NumberOptional Accessories Portable and Laptop Activation Chart Key command to Computer Activate port De-activate portFN-F6 FN-F4 FN-F1 NCR Wyse Software driven Zenith FN-F10 Using Video Mirroring with a PowerBook Computer Projected Image Size FeetD E Index D e Page Page Limited Warranty Part Number