InFocus 330 Problem Image is out of focus, Problem Image and menus are reversed left to right

Page 45

Problem: Image is out of focus

•Turn the projection lens to focus the image.

•Make sure the projection screen is at least 5 feet (1.5 m) from the projector.

•Check the projection lens to see if it needs cleaning.

Problem: Image and menus are reversed left to right

•Rear projection mode is probably turned on. Turn Rear Projec- tion off in the Controls menu. The image should immediately return to forward projection. See “Rear Projection” on

page 24.

Problem: the projector displays vertical lines, “bleeding” or spots

•Adjust the brightness. See “Brightness” on page 19.

•Check the projection lens to see if it needs cleaning.

Problem: no sound

•Adjust volume.

•Verify audio/input connections.

•Adjust audio source.

Problem: Image is “noisy” or streaked

Try these steps in this order.

1Deactivate the screen saver on your computer.

2Turn Auto Image off and then back on again. See “Auto Image” on page 21.

3Turn Auto Image off and adjust the synchronization and track- ing manually to find an optimal setting. See “Manual Sync” on page 21 and “Manual Tracking” on page 22.

•The problem could be with your computer’s video card. If possible, connect a different computer.

33

Image 45

Contents I D E Page Safety Certifications Declaration of Conformity Table of Contents Index AppendixSafety Instructions F e t y S t r u c t i o n s T R O D U C T I O N Introduction Image ResolutionCompatibility Unpacking the ProjectorT r o d u c t i o n Usage Guidelines If You Need Assistance WarrantySetting UP Projector Setting UP the Projector T t i n g O j e c t o r Connecting a Computer T t i n g O j e c t o r Audio Adapter Composite video cable Audio cable Connecting a Video PlayerCable Powering up the Projector and Adjusting the Image Turning Off the Projector Using Projector Using the Projector Basic Image AdjustmentUsing the Remote Control I n g O j e c t o r Adjusting the Projector Using the Keypad and Remote Buttons Standby Using the On-Screen Menus Display Menu Audio Menu Image Menu I n g O j e c t o r Position and Vert. Position Controls Menu Rear Projection Language Menu Status Menu I N T E N a N C E Troubleshooting Maintenance & Troubleshooting Cleaning the LensReplacing the Projection Lamp Pull the lamp door up and remove it Lift and grasp the pull tab and lift the module out Figure Using the Kensington Lock Replacing the Batteries in the Remote ControlProblem Color or text not being projected Troubleshooting Problem Nothing on projection screenProblem The screen resolution is not right Problem Image isn’t centered on the screenProblem Image is too wide or narrow for screen Problem Image and menus are reversed left to right Problem Image is out of focusProblem no sound Problem Image is noisy or streakedProblem Lamp shuts off Problem Lamp seems to be getting dimmerP E N D I Appendix SpecificationsStandard Accessories Ship with the projector Part Number AccessoriesOptional Accessories Key command to Computer Activate port De-activate port Portable and Laptop Activation ChartFN-F6 FN-F4 FN-F1 NCR Wyse Software driven Zenith FN-F10 Using Video Mirroring with a PowerBook Computer Feet Projected Image SizeD E Index D e Page Page Limited Warranty Part Number