InFocus 330 manual Usage Guidelines

Page 12

speaker

keypad

zoom ring

	Kensington Lock
focus ring	connector panel
focus ring
	power
	cord
	connector
	FIGURE 2

Side view of projector

Usage Guidelines

•Do not look directly into the projection lens when the lamp is turned on. The bright light may harm your eyes.

•Do not block the grills on the projector. Restricting the air flow can cause it to overheat and turn off. If this happens, you must wait a minute before attempting to turn it back on.

•Handle the projector as you would any product with glass components. Be especially careful not to drop it.

•Avoid leaving the projector in direct sunlight or extreme cold for extended periods of time. If this happens, allow it to reach room temperature before use.

•Transport the projector in a vendor-approved hard or soft case. Part numbers for these cases are listed on page 37.

3

Image 12

Contents I D E Page Safety Certifications Declaration of Conformity Table of Contents Appendix IndexSafety Instructions F e t y S t r u c t i o n s T R O D U C T I O N Image Resolution IntroductionCompatibility Unpacking the ProjectorT r o d u c t i o n Usage Guidelines Warranty If You Need AssistanceSetting UP Projector Setting UP the Projector T t i n g O j e c t o r Connecting a Computer T t i n g O j e c t o r Connecting a Video Player Audio Adapter Composite video cable Audio cableCable Powering up the Projector and Adjusting the Image Turning Off the Projector Using Projector Using the Projector Basic Image AdjustmentUsing the Remote Control I n g O j e c t o r Adjusting the Projector Using the Keypad and Remote Buttons Standby Using the On-Screen Menus Display Menu Audio Menu Image Menu I n g O j e c t o r Position and Vert. Position Controls Menu Rear Projection Language Menu Status Menu I N T E N a N C E Troubleshooting Maintenance & Troubleshooting Cleaning the LensReplacing the Projection Lamp Pull the lamp door up and remove it Lift and grasp the pull tab and lift the module out Figure Replacing the Batteries in the Remote Control Using the Kensington LockTroubleshooting Problem Nothing on projection screen Problem Color or text not being projectedProblem The screen resolution is not right Problem Image isn’t centered on the screenProblem Image is too wide or narrow for screen Problem Image is out of focus Problem Image and menus are reversed left to rightProblem no sound Problem Image is noisy or streakedProblem Lamp seems to be getting dimmer Problem Lamp shuts offP E N D I Specifications AppendixAccessories Standard Accessories Ship with the projector Part NumberOptional Accessories Portable and Laptop Activation Chart Key command to Computer Activate port De-activate portFN-F6 FN-F4 FN-F1 NCR Wyse Software driven Zenith FN-F10 Using Video Mirroring with a PowerBook Computer Projected Image Size FeetD E Index D e Page Page Limited Warranty Part Number