InFocus 330 manual Appendix, Specifications

Page 48

APPENDIX

Specifications

The LP330 must be operated and stored within the temperature and humidity ranges specified.

Temperature
Operating	50 to 104° F (10 to 40° C)
Non-operating	-4 to 158° F (-20 to 70° C)
Humidity

Operating and non-oper.	5% to 95% relative humidity, non-condensing

Dimensions

8.75 x 9.75 x 2.5 inches (22.2 x 24.8 x 6.4 cm)

Weight

4.8 lbs. (2.2 kg) unpacked

Altitude

Operating	0 to 10,000 feet (3,048 meters)
Non-operating	0 to 40,000 feet (12,192 meters)
Optics

Focus Range	4.9 - 16 feet (1.5-5 m)
Lamp

Type	120-watt VHP lamp

Input Power Requirements

100-120VAC 6A;50/60Hz

200-240VAC 3A; 50Hz

Audio Input

Input Impedance	10K ohm nominal, AC coupled
Maximum Input Voltage	(LIN + RIN)PEAK < 4.5 V for THD ≤ 0.3%
	LIN or RIN < 2.0 Vrms for THD ≤ 0.3%
Sensitivity	100 mV at 1 KHz for 88 dB SPL at 1 meter
Connector Type	3.5 mm (1/8 inch) stereo phone mini

35

Image 48

Contents I D E Page Safety Certifications Declaration of Conformity Table of Contents Appendix IndexSafety Instructions F e t y S t r u c t i o n s T R O D U C T I O N Image Resolution IntroductionCompatibility Unpacking the ProjectorT r o d u c t i o n Usage Guidelines Warranty If You Need AssistanceSetting UP Projector Setting UP the Projector T t i n g O j e c t o r Connecting a Computer T t i n g O j e c t o r Connecting a Video Player Audio Adapter Composite video cable Audio cableCable Powering up the Projector and Adjusting the Image Turning Off the Projector Using Projector Using the Projector Basic Image AdjustmentUsing the Remote Control I n g O j e c t o r Adjusting the Projector Using the Keypad and Remote Buttons Standby Using the On-Screen Menus Display Menu Audio Menu Image Menu I n g O j e c t o r Position and Vert. Position Controls Menu Rear Projection Language Menu Status Menu I N T E N a N C E Troubleshooting Maintenance & Troubleshooting Cleaning the LensReplacing the Projection Lamp Pull the lamp door up and remove it Lift and grasp the pull tab and lift the module out Figure Replacing the Batteries in the Remote Control Using the Kensington LockTroubleshooting Problem Nothing on projection screen Problem Color or text not being projectedProblem The screen resolution is not right Problem Image isn’t centered on the screenProblem Image is too wide or narrow for screen Problem Image is out of focus Problem Image and menus are reversed left to rightProblem no sound Problem Image is noisy or streakedProblem Lamp seems to be getting dimmer Problem Lamp shuts offP E N D I Specifications AppendixAccessories Standard Accessories Ship with the projector Part NumberOptional Accessories Portable and Laptop Activation Chart Key command to Computer Activate port De-activate portFN-F6 FN-F4 FN-F1 NCR Wyse Software driven Zenith FN-F10 Using Video Mirroring with a PowerBook Computer Projected Image Size FeetD E Index D e Page Page Limited Warranty Part Number