InFocus 220, 210 manual Usage Guidelines, If You Need Assistance, Warranty

I n t r o d u c t i o n

NOTE: If the LitePro overheats and turns off, you must wait about 45 seconds before you attempt to turn it back on.

Usage Guidelines

•Do not look directly into the projection lens when the projector is turned on. The bright light may harm your eyes.

•The top and bottom of the projector can be very hot to the touch after use. Use extreme care or let it cool before lifting it.

•Do not block the grills at the front or top of the projector. Restricting the air flow can cause it to overheat and turn off.

•Handle the projector as you would any product with glass components. Be especially careful not to drop it.

•Avoid leaving the projector in direct sunlight or extreme cold for extended periods of time. If this happens, allow it to reach room temperature before use.

•Transport the projector in a vendor-approved hard or soft case. Part numbers for these cases are listed on page 57. Call your In Focus dealer to order.

If You Need Assistance

The first place to look for help is in this manual. Be sure to check the guidelines in “Troubleshooting” on page 49.

If this manual doesn’t answer your question, call your In Focus dealer. You can also call In Focus Customer Service directly at 1-800-799-9911. Call between 6 a.m. and 5 p.m. PST, Monday through Friday. In Europe, call In Focus in The Netherlands at

(31)23-5623200. In Singapore, call (65) 334-9005. Or, send us an e-mail at techsupport@infs.com.

The In Focus World Wide Web address is http://www.infs.com.

Warranty

These products are backed by a limited one-year warranty. The details of the warranty are printed at the back of this manual. Longer term warranties can be purchased from your In Focus dealer. Refer to page 58 for part numbers.

4