Onkyo CR-L5 Using the Radio, Presetting FM Stations, Automatically, Presetting Stations Manually

Page 22

CR-L5_E.book Page 22 Monday, May 19, 2003 4:05 PM

Using the Radio

 

 

DISPLAY

 

Presetting FM Stations

 

 

 

 

Automatically

STANDBY / ON

 

 

 

 

STANDBY

 

PAUSE

STOP

PLAY

PHONES

 

 

 

With the Auto Preset function you can automatically preset

SPEAKERS A / B MEMORY FM MODE

 

DISPLAY

INPUT

DIRECT

CLEAR

TUNING

PRESET

 

all the FM stations available in your area.

 

TUNING

PRESET

 

1 Use the INPUT [ ]/[ ] buttons, or the

MEMORY

FM MODE

INPUT

remote controller’s INPUT []/[ ] but- tons to select FM.

INPUT /

ON

STANDBY

 

 

 

 

 

 

TONE

 

INPUT

 

 

 

 

 

TIMER

 

1

2

3

 

 

4

5

6

 

7

8

9

 

>10

10/0

ENTER

 

 

SLEEP

VOLUME

 

 

 

UP

 

 

 

 

MUTING

 

 

CLOCK CALL

DOWN

DIRECT

 

DIMMER

 

 

DISPLAY

DISPLAY

 

 

 

 

2 Press and hold the [MEMORY] button until “Auto Preset” flashes on the dis- play.

Hold down the button for a few more seconds until the Auto Preset function starts.

The Auto Preset function scans the FM band from low to high, presetting up to 30 stations with strong signals.

Note: All previously stored presets will be overwritten when the Auto Preset function is used again.

CD

PLAY MODE

 

 

CDRCLEAR

Presetting Stations Manually

TAPEREPEAT

Tuning the Radio

You can preset up to 40 of your favorite AM and FM radio stations in total.

1 Use the INPUT []/[ ] buttons, or the remote controller’s INPUT []/[ ] but- tons to select AM or FM.

2 Use the TUNING []/[ ] buttons, or the remote controller’s []/[ ] buttons to tune the radio.

If you select the FM band:

To automatically search for a station, press and hold a TUNING []/[ ] button for more than half a second and then release it. The CR-L5 searches for the next station. Searching stops when a station is found and the

Tuned and FM STEREO indicators appear. If necessary, you can use the TUNING [ ]/[ ] buttons for fine tuning.

The FM band is searched in 0.05 MHz intervals.

If you select the AM band:

Press the TUNING [] or [ ] button to change the fre- quency one interval at a time, or press and hold the but- ton to quickly change the frequency. When you’re

tuned into a station, the Tuned indicator appears. The AM band is searched in 9 kHz intervals.

Tuning into weak FM stations

If a station has a poor signal strength, you may not be able to tune into that station properly, or reception may be noisy. In this case, press the [FM MODE] button. The AUTO and FM STEREO indicators go off and mono mode is selected.

22

1 Tune into the station that you want to store as a preset.

2 Press the [MEMORY] button.

The preset number flashes.

3 While the preset number is flashing, use the PRESET []/[ ] buttons to select a preset from 1 through 40.

In this example, preset #3 has been selected.

4 Press the [MEMORY] button to store the station.

The station is stored and the preset number stops flash- ing.

Repeat this procedure for all of your favorite radio sta- tions.

Notes:

If you try to store more than 40 stations, the message “Memory Full” appears on the display.

When the CR-L5 is tuned into a station that’s transmitting PS (Program Service Name) RDS information, the sta- tion’s name will be displayed instead of the frequency.

Image 22
Contents CR-L5 Important Safeguards Important Safeguards Damage Requiring Service-Unplug the applianceRecording Copyright PowerInstalling This Unit AC FusePrecautions FeaturesMemory backup About playing copy-controlled CDs Supplied AccessoriesDisc Notes AM loop antenna FM indoor antennaUsing the Remote Controller Before Using the CR-L5Installing the Remote Controller Batteries Open the battery compartment, as shownFront Panel Controls & ConnectorsDisplay Rear Panel Remote Controller Connecting Your Other Components to the CR-L5 Cassette Tape Deck CD recorderHookup Example Connecting -compatible ComponentsOnkyo CD recorder Speakers Set a Connecting Your SpeakersStrip 15 mm 5/8 Speakers Set BConnecting the Indoor FM Antenna Connecting AntennaConnecting the AM Loop Antenna Attach the FM antenna, as shownConnecting Antenna Connecting an Outdoor FM AntennaConnecting an Outdoor AM Antenna AM loop antennaFirst Time Setup Powering Up and Setting the ClockPowering Up the CR-L5 Turning Off AccuclockSetting Accuclock to Use a Specific Station Displaying the Time in Standby ModeDisplaying the Day & Time Use the Up/Down / buttons to set the time Setting the Clock ManuallyUse the Up/Down / buttons to select a day Press the Enter button to set the clockUsing Headphones Using the CR-L5Adjusting the Volume Selecting Sound SourcesPlaying CDs Random Playback To Cancel Memory PlaybackRepeat Playback To Stop Memory PlaybackPresetting Stations Manually Using the RadioPresetting FM Stations Tuning the RadioTons to select a preset Selecting PresetsDeleting Presets Select the preset that you want to deleteNaming Presets Editing Preset Names Displaying a Preset Station’s FrequencyUsing Direct Mode Adjusting the Bass & TrebleAdjusting the Display Brightness Other FunctionsTimer Examples TimersAbout the Timers Setting the TimersPress the Standby button to set the CR-L5 to Standby mode Using the Sleep Timer Turning Timers OffChecking Timer Settings Use the Up/Down / buttons to select Timer OffTroubleshooting Troubleshooting Restoring the Default Settings Abnormal BehaviorSpecifications Onkyo Europe Electronics GmbH