Onkyo CR-L5 Turning Timers Off, Checking Timer Settings, Using the Sleep Timer, Sleep indicator

CR-L5_E.book Page 28 Monday, May 19, 2003 4:05 PM

Timers—Continued

Turning Timers Off

You can turn timers on or off as necessary. This can be use- ful when, for example, you’re on holiday and you don’t want to be woken up by the timer that you normally use as an early-morning radio alarm.

ON	STANDBY
			TONE
▼	▲	INPUT
			TIMER
1	2	3	TIMER
4	5	6	▲
7	8	9	▼
>10	10/0	ENTER	ENTER
SLEEP	VOLUME
SLEEP	UP
	MUTING
CLOCK CALL	DOWN		DIRECT

1 Press the [TIMER] button repeatedly to select the timer that you want to turn off.

In this example, timer #1 is selected.

Checking Timer Settings

You can check a timer’s settings as follows.

1 Press the [TIMER] button repeatedly to select the timer that you want to check.

In this example, timer #1 is selected.

2 Press the [ENTER] button repeatedly to cycle through the timer’s settings.

Notes:

• You can edit the selected timer’s settings as you check them. To do this, use the Up/Down []/[ ] buttons to edit the currently displayed setting, and then press [ENTER] to move on to the next setting.

•If the selected timer was OFF, and you edit its settings, it will be turned ON.

2 Use the Up/Down []/[ ] buttons to select Timer Off.

The timer is turned off, and the previous display reap- pears after two seconds.

To turn a timer back on again, repeat this procedure and use the Up/Down []/[ ] buttons to select Timer On.

Using the Sleep Timer

With the sleep timer you can set the CR-L5 so that it auto- matically turns off after a specified period.

1 Press the [SLEEP] button repeatedly to select the required sleep time.

With the [SLEEP] button you can set the sleep time from 90 to 10 minutes in 10 minute steps.

While the sleep time is displayed, you can use the remote controller’s Up/Down []/[ ] buttons to set the sleep time in 1 minute steps from 99 to 1.

The SLEEP indicator appears on the display when the sleep timer has been set, as shown. The specified sleep time appears on the display for about five seconds, then the previous display reappears.

SLEEP indicator

To cancel the sleep timer, press the [SLEEP] button repeatedly until the SLEEP indicator disappears.

To check the remaining sleep time, press the [SLEEP] button. Note that if you press the [SLEEP] button while the sleep time is being displayed, you’ll shorten the sleep time by 10 minutes.

28