Onkyo CR-L5 instruction manual Abnormal Behavior, Restoring the Default Settings

Page 31

CR-L5_E.book Page 31 Monday, May 19, 2003 4:05 PM

Troubleshooting—Continued

Trouble

Possible Cause

Remedy

 

 

 

It takes a long time to locate

The disc is dirty.

Remove the disc and clean it (page 6).

certain tracks?

The disc is very scratched.

Buy a new disc.

 

 

 

 

CT (Clock Time) information has been

Set ACCUCLOCK to use a specific station

The clock is wrong?

taken from a radio station in another time

(page 17).

 

zone.

 

 

 

 

 

The CR-L5 turns itself on

The ACCUCLOCK function is updating the

This is not a malfunction. The CR-L5 will

turn itself off automatically when the ACCU-

unexpectedly?

clock.

CLOCK function has updated the clock.

 

 

 

 

 

 

The CR-L5 was already on at the specified

Set the CR-L5 to Standby (page 27). The CR-

 

L5 must be in Standby mode, otherwise the

 

ON time.

The timer didn’t work?

timed task will not work.

 

 

The specified ON time coincided, or over-

Check the timer settings and correct as neces-

 

lapped the ON time of another timer.

sary (page 28).

 

 

 

 

While a timed recording task is in progress,

To hear what’s being recorded, press the

No sound is output when a

[MUTING] button to cancel the Mute func-

the output of the CR-L5 is muted.

timed playback or record-

tion. Press it again to mute the CR-L5.

 

ing task starts?

For timed playback, the volume is deter-

Set the volume to a suitable level (page 19).

 

mined by the VOLUME control.

 

 

 

 

 

Abnormal Behavior

The CR-L5 contains a microcomputer for signal processing and control functions. In very rare situations, severe interfer- ence, noise from an external source, or static electricity may cause it to lockup. In the unlikely even that this should happen, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again.

Restoring the Default Settings

To reset the CR-L5 to its factory defaults, turn it on and, while holding down the STOP [] button, press the [STANDBY/ ON] button. Press the [STANDBY/ON] button again. “Initialized” appears on the display and the CR-L5 is reset to its factory defaults.

31

Page 30 Page 32
Image 31
Page 30 Page 32
Contents CR-L5 Important Safeguards Damage Requiring Service-Unplug the appliance Important SafeguardsAC Fuse PowerInstalling This Unit Recording CopyrightPrecautions FeaturesMemory backup AM loop antenna FM indoor antenna Supplied AccessoriesDisc Notes About playing copy-controlled CDsOpen the battery compartment, as shown Before Using the CR-L5Installing the Remote Controller Batteries Using the Remote ControllerFront Panel Controls & ConnectorsDisplay Rear Panel Remote Controller Cassette Tape Deck CD recorder Connecting Your Other Components to the CR-L5Hookup Example Connecting -compatible ComponentsOnkyo CD recorder Speakers Set B Connecting Your SpeakersStrip 15 mm 5/8 Speakers Set aAttach the FM antenna, as shown Connecting AntennaConnecting the AM Loop Antenna Connecting the Indoor FM AntennaAM loop antenna Connecting an Outdoor FM AntennaConnecting an Outdoor AM Antenna Connecting AntennaTurning Off Accuclock Powering Up and Setting the ClockPowering Up the CR-L5 First Time SetupSetting Accuclock to Use a Specific Station Displaying the Time in Standby ModeDisplaying the Day & Time Press the Enter button to set the clock Setting the Clock ManuallyUse the Up/Down / buttons to select a day Use the Up/Down / buttons to set the timeSelecting Sound Sources Using the CR-L5Adjusting the Volume Using HeadphonesPlaying CDs To Stop Memory Playback To Cancel Memory PlaybackRepeat Playback Random PlaybackTuning the Radio Using the RadioPresetting FM Stations Presetting Stations ManuallySelect the preset that you want to delete Selecting PresetsDeleting Presets Tons to select a presetDisplaying a Preset Station’s Frequency Naming Presets Editing Preset NamesOther Functions Adjusting the Bass & TrebleAdjusting the Display Brightness Using Direct ModeSetting the Timers TimersAbout the Timers Timer ExamplesPress the Standby button to set the CR-L5 to Standby mode Use the Up/Down / buttons to select Timer Off Turning Timers OffChecking Timer Settings Using the Sleep TimerTroubleshooting Troubleshooting Abnormal Behavior Restoring the Default SettingsOnkyo Europe Electronics GmbH Specifications
Top Page Image Contents