Onkyo instruction manual Before Using the CR-L5, Installing the Remote Controller Batteries

CR-L5_E.book Page 7 Monday, May 19, 2003 4:05 PM

Before Using the CR-L5

Installing the Remote Controller Batteries

1 Open the battery compartment, as shown.

Using the Remote Controller

To use the remote controller, point it at the CR-L5’s remote control sensor, as shown below.

Remote control

sensor

CR-L5

2 Insert the two supplied batteries (AA/

R6) in accordance with the polarity diagram inside the battery compart- ment.

30˚

Notes:

30˚

3 Close the battery compartment.

Notes:

•The supplied batteries should last for about six months, although this will vary with usage.

•If the remote controller doesn’t work reliably, try replac- ing both batteries.

•Don’t mix new and old batteries, or different types of bat- teries.

•If you intend not to use the remote controller for a long time, remove the batteries to prevent possible leakage and corrosion.

•Flat batteries should be removed as soon as possible to prevent possible leakage and corrosion.

•The remote controller may not work reliably if the CR-L5 is subjected to bright light, such as direct sunlight or inverter-type fluorescent lights. Keep this in mind when installing the CR-L5.

•If another remote controller of the same type is used in the same room, or the CR-L5 is installed close to equip- ment that uses infrared rays, the remote controller may not work reliably.

•Don’t put anything, such as a book, on the remote con- troller, because the buttons may be pressed inadvertently, thereby draining the batteries.

•The remote controller may not work reliably if the CR-L5 is installed in a rack behind colored glass doors. Keep this in mind when installing the CR-L5.

•The remote controller will not work if there’s an obstacle between it and the CR-L5’s remote control sensor.

7