twinax connection
Attach twinax cables
Attach the twinax cable from the host computer to the "Smart T" connected to the printer earlier.
1 If there is an up cable device connected to the twinax cable (from the host), the twinax cable must originate from the "OUT" connector of that device. The other end of this cable attaches to either side of the "Smart T" connected to the printer.
2 If this printer is the last or only device on the twinax line, the twinax cable attaches to either side of the "Smart T" connected to the printer.
3 If there is a down cable device, connect the other twinax cable to either side of the "Smart T".
Address switch
Before testing, do the following:
1 Verify that the printer address matches the one set up on your host system. The I/O address should be unique on the twinax line. BE CERTAIN THAT NO ADDRESS ON THE LINE IS DUPLICATED!!!
To set the printer address, rotate the address switch, on the I/O, to the number that corresponds to the address setting for your environment. This address should be some number between 0 and 6.
2 Verify that the address matches the
one set up on your host system configuration.
31 |