hardware installation
4 Using two of the supplied Phillips screws, mount the controller I/O assembly in the area formerly occupied by the printer's interface expansion slot cover.
Use the third Phillips screw to mount the
5 Connect the printer’s Centronics data cable to the connector P3 on the Multi- Platform Interface PCBA. This will supply connection to the PC environment.
Make certain that none of the cables are Figure 9 pinched by the installation of the MPI card.
Printer interface area after installing the
Attaching the MPI Label
Attach the MPI Label, part number 145594, on the printer, near the MPI. This label provides information about the MPI connections and is needed, if service is required.
84 |