JVC GD-V501PCE manual Select the input signal, Selecting the On-Screen Menu Language

Page 15

Power On/Off and input signal selection

Select the input signal

INPUT

+

INPUT VOL +

Press the INPUT button to select the input signal to be played back from the equipment which has been connected to the Plasma Display.

Select the input signals to be connected by installing the optional Video Input Card.

(see page 30)

Input signals will change as follows:

INPUT

SURROUND

VOL

NR

For Component Input

AV Component PC

For RGB Input

AV RGB PC

Note:

Input buttons do not work if no optional Video Input Card is installed.

Selecting the On-Screen Menu Language

INPUT

SET UP

Press to display the Set Up menu.

Press to select the OSD Language.

SURROUND

VOL

NR

PICTURE

SOUND

SET UP

Press to select your preferred language.

Selectable languages

English(UK)

Deutsch

Français

Italiano

Español

ENGLISH(US)

.......(Chinese)

Setup

 

Component/RGB-in select

RGB

 

Signal

 

Screensaver

English (UK)

OSD Language

Set up TIMER

 

15

Image 15
Contents Plasma Display Monitor GD-V501PCEINSTRUCTIONS Table of Contents Trademark Credits Important Safety NoticeFor UK only Important the Moulded Plug Important Safety NoticeSafety Precautions SetupWhen using the Plasma Display Cleaning and maintenance Safety PrecautionsIf problems occur during use Check that you have the accessories and items shown AccessoriesAccessories Supply Optional AccessoriesHelpful Hint Remote Control BatteriesPrecaution on battery use Observe the following precautionCable fixing bands ConnectionsPC Input Terminals connection Installing the ferrite core Small sizeInstalling the ferrite core Large size Signal Names for D-sub 15P ConnectorCommunication parameters Installing the ferrite coreCommand Serial Terminals connectionBasic Controls Basic Controls Input button AVS Video, Component/RGB and PC Mode SelectionSound mute On/Off see Volume Adjustment OFF Timer buttonAC cord connection Power On/Off and input signal selectionPower On/Off Connecting the plug to the Wall OutletSelect the input signal Power On/Off and input signal selectionSelecting the On-Screen Menu Language To Picture adjust menu Press to select each item See On-Screen Menu Display from Remote ControlSee page 30 Component see To Signal screen for PC see On-Screen Menu Display from Remote ControlAspect Controls Auto Aspect ControlsZoom JustAdjusting screen Adjusting Picture Pos./SizePos Adjusting Picture Pos./SizeSize Clock Phase RGB/PC in Mode Helpful Hint N / Normalise NormalisationTreble Sound AdjustmentMute BassSurround Controls On OffSurround Surround Button Cinema Picture AdjustmentsNormal DynamicPicture Adjustments Advanced SettingsPresent Time Set Set up TimerSetup Timer Timer SetTo stop the Screensaver under On, press the button Mode selectionScreensaver For preventing after-images Reversal / Scroll selectionSetup of Screensaver Time Side Panel AdjustmentScreensaver For preventing after-images Setup for Input Signals Component/RGB-in Select3D Y/C Filter For Ntsc AV images If the picture image becomes unstable Setup for Input SignalsColour system / Aspect Auto PulldownFreq. kHz/V-Freq. Hz Setup for input signals SyncSetting RGB sync signal Setting PC sync signalPlasma Display panel Symptoms Check TroubleshootingPC RGB input AV input signalsComponent /RGB/PC input signals Connection to the Optional Video Input Card. IF-C50P1GVideo signal connection AV Input Terminals connectionVideo 4 pin socket AV Out Component signals Y, PB, PR connection RGB signal R, G, B, HD, VD connectionComponent/RGB Input connection Specifications Optional Supplied SpecificationsDimensions Mass WeightGD-V501PCE Plasma Display Monitor