JVC GD-V501PCE manual Remote Control Batteries, Helpful Hint, Precaution on battery use

Page 8

Remote Control Batteries

Requires two R6 batteries.

1.Turn the transmitter face down. Press and slide off the battery cover.

2.Install the batteries as shown in the battery compartment. (Polarity + or – must match the markings in the compartment.)

3.Replace the cover and slide in reverse until the lock snaps.

Two "R6" size

Helpful Hint:

For frequent remote control users, replace old batteries with

Alkaline batteries for longer life.

Precaution on battery use

Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.

Observe the following precaution:

1.Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set.

2.Do not combine a used battery with a new one.

3.Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).

4.Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.

5.Battery replacement is necessary when remote control acts sporadically or stops operating the Plasma Display set.

8

Image 8

Contents Plasma Display Monitor GD-V501PCEINSTRUCTIONS Table of Contents Important Safety Notice Trademark CreditsImportant Safety Notice For UK only Important the Moulded PlugWhen using the Plasma Display Safety PrecautionsSetup If problems occur during use Cleaning and maintenanceSafety Precautions Accessories Accessories SupplyOptional Accessories Check that you have the accessories and items shownRemote Control Batteries Precaution on battery useObserve the following precaution Helpful HintConnections Cable fixing bandsInstalling the ferrite core Small size Installing the ferrite core Large sizeSignal Names for D-sub 15P Connector PC Input Terminals connectionInstalling the ferrite core CommandSerial Terminals connection Communication parametersBasic Controls Input button AVS Video, Component/RGB and PC Mode Selection Sound mute On/Off see Volume AdjustmentOFF Timer button Basic ControlsPower On/Off and input signal selection Power On/OffConnecting the plug to the Wall Outlet AC cord connectionSelecting the On-Screen Menu Language Select the input signalPower On/Off and input signal selection On-Screen Menu Display from Remote Control To Picture adjust menu Press to select each item SeeOn-Screen Menu Display from Remote Control See page 30 Component see To Signal screen for PC seeAspect Controls Aspect Controls ZoomJust AutoAdjusting Picture Pos./Size Adjusting screenAdjusting Picture Pos./Size Size Clock Phase RGB/PC in ModeHelpful Hint N / Normalise Normalisation PosSound Adjustment MuteBass TrebleSurround Surround Button Surround ControlsOn Off Picture Adjustments NormalDynamic CinemaAdvanced Settings Picture AdjustmentsSet up Timer Present Time SetTimer Set Setup TimerMode selection Screensaver For preventing after-imagesReversal / Scroll selection To stop the Screensaver under On, press the buttonScreensaver For preventing after-images Setup of Screensaver TimeSide Panel Adjustment 3D Y/C Filter For Ntsc AV images Setup for Input SignalsComponent/RGB-in Select Setup for Input Signals Colour system / Aspect AutoPulldown If the picture image becomes unstableSetup for input signals Sync Setting RGB sync signalSetting PC sync signal Freq. kHz/V-Freq. HzTroubleshooting Plasma Display panel Symptoms CheckAV input signals Component /RGB/PC input signalsConnection to the Optional Video Input Card. IF-C50P1G PC RGB inputVideo 4 pin socket Video signal connectionAV Input Terminals connection AV Out Component/RGB Input connection Component signals Y, PB, PR connectionRGB signal R, G, B, HD, VD connection Specifications Specifications DimensionsMass Weight Optional SuppliedGD-V501PCE Plasma Display Monitor