JVC GD-V501PCE manual Connections, Cable fixing bands

Page 9

Connections

When connecting the speakers, be sure to use only the optional accessory speakers. Refer to the speaker’s Installation Manual for details on speaker installation.

Speakers (Optional accessories)

SPEAKERS Terminals (R)

	AC cord connection	SPEAKERS
		Terminals (L)
	(see page 14)

–Cable fixing bands

Secure any excess cables with bands as required.

Pass the attached cable fixing band through the clip as shown in the figure.

To secure cables connected to Terminals, wrap the cable fixing band around them then pass the pointed end through the locking block, as shown in the figure.

While ensuring there is sufficient slack in cables to minimize stress (especially in the power cord), firmly bind all cables with the supplied fixing band.

To tighten:

Pull

To loosen:

Push the catch

Pull

		AUDIO
PC	IN	SERIAL

From EXIT monitor terminal on Computer (see page 10)

From SERIAL Terminal on Computer (see page 11)

Image 9

Contents Plasma Display Monitor GD-V501PCEINSTRUCTIONS Table of Contents Trademark Credits Important Safety NoticeFor UK only Important the Moulded Plug Important Safety NoticeSafety Precautions SetupWhen using the Plasma Display Cleaning and maintenance Safety PrecautionsIf problems occur during use Accessories Supply AccessoriesOptional Accessories Check that you have the accessories and items shownPrecaution on battery use Remote Control BatteriesObserve the following precaution Helpful HintCable fixing bands ConnectionsInstalling the ferrite core Large size Installing the ferrite core Small sizeSignal Names for D-sub 15P Connector PC Input Terminals connectionCommand Installing the ferrite coreSerial Terminals connection Communication parametersBasic Controls Sound mute On/Off see Volume Adjustment Input button AVS Video, Component/RGB and PC Mode SelectionOFF Timer button Basic ControlsPower On/Off Power On/Off and input signal selectionConnecting the plug to the Wall Outlet AC cord connectionSelect the input signal Power On/Off and input signal selectionSelecting the On-Screen Menu Language To Picture adjust menu Press to select each item See On-Screen Menu Display from Remote ControlSee page 30 Component see To Signal screen for PC see On-Screen Menu Display from Remote ControlAspect Controls Zoom Aspect ControlsJust AutoAdjusting screen Adjusting Picture Pos./SizeSize Clock Phase RGB/PC in Mode Adjusting Picture Pos./SizeHelpful Hint N / Normalise Normalisation PosMute Sound AdjustmentBass TrebleSurround Controls On OffSurround Surround Button Normal Picture AdjustmentsDynamic CinemaPicture Adjustments Advanced SettingsPresent Time Set Set up TimerSetup Timer Timer SetScreensaver For preventing after-images Mode selectionReversal / Scroll selection To stop the Screensaver under On, press the buttonSetup of Screensaver Time Side Panel AdjustmentScreensaver For preventing after-images Setup for Input Signals Component/RGB-in Select3D Y/C Filter For Ntsc AV images Colour system / Aspect Auto Setup for Input SignalsPulldown If the picture image becomes unstableSetting RGB sync signal Setup for input signals SyncSetting PC sync signal Freq. kHz/V-Freq. HzPlasma Display panel Symptoms Check TroubleshootingComponent /RGB/PC input signals AV input signalsConnection to the Optional Video Input Card. IF-C50P1G PC RGB inputVideo signal connection AV Input Terminals connectionVideo 4 pin socket AV Out Component signals Y, PB, PR connection RGB signal R, G, B, HD, VD connectionComponent/RGB Input connection Specifications Dimensions SpecificationsMass Weight Optional SuppliedGD-V501PCE Plasma Display Monitor