Onkyo PR-SC5508 Using a Multiroom Kit with Zone 2/3, Using a Multiroom Kit with a Cabinet

Page 80

Using the Remote Controller in Zone 2/3 and Multiroom Control Kits

To control the AV controller with the remote controller while you’re in Zone 2 or Zone 3, you’ll need a commer- cially available multiroom remote control kit for each zone.

• Multiroom kits are made by Niles and Xantech.

These kits can also be used when there isn’t a clear line of sight to the AV controller’s remote sensor, such as when it’s installed inside a cabinet.

Using a Multiroom Kit with Zone 2/3

In this setup, the IR receiver in Zone 2/3 picks up the infrared signals from the remote controller and feeds them through to the AV controller in the main room via the con- necting block.

Using a Multiroom Kit with a Cabinet

In this setup, the IR receiver picks up the infrared signals from the remote controller and feeds them to the AV con- troller located in the cabinet via the connecting block.

IR

Connecting receiver block

IR IN

Inside

Remote controller

cabinet

Signal flow

 

IR IN

Connect- ing block

Main room

Signal flow

IR receiver

Remote controller

Zone 2/3

Using a Multiroom Kit with Other

Components

In this setup, an IR emitter is connected to the AV control- ler’s IR OUT jack and placed in front of the other compo- nent’s remote control sensor. Infrared signals received at the AV controller’s IR IN jack are fed through to the other component via the IR emitter. Signals picked up by the AV controller’s remote control sensor are not output.

Connecting

IR receiver

 

block

 

IR IN

 

The miniplug cable from the connecting block should be connected to the AV controller’s IR IN jack, as shown below.

From the connecting block

Miniplug cable

AV controller

Signal flow

En

IR OUT

AV control-

ler

 

 

IR Emitter

 

Remote controller

 

Other component

Signal flow

The IR emitter should be connected to the AV controller’s IR OUT jack, as shown below.

Miniplug cable

 

Other component

 

 

Remote

AV controller

control

sensor

Emitter

IR Emitter

 

Miniplug

 

Signal flow

 

80

Image 80
Contents Introduction Connections Advanced Operations Controlling iPod & Other ComponentsAlways consider the environmental issues and follow 10 cm 4 at the rear. The rear edge of the shelf orBoard above the apparatus shall be set 10 cm Away from the rear panel or wall, creating a flue-likePrecautions Supplied Accessories Using the Remote ControllerInstalling the Batteries Aiming the Remote ControllerContents Features ProcessingMiscellaneous Analog RGB Video Input D-sub 15 for PCMusic Optimizer is a trademark of Onkyo Corporation THX Ultra2 PlusV.Color is a trademark of Sony Corporation Pure Audio button Hdmi Thru indicator Front & Rear PanelsFront Panel ON/STANDBY buttonReturn button Setup MIC jack DisplayPhones jack Zone 2, Zone 3 and OFF buttons AUX Input jacks HDMI, VIDEO, Audio L/R and Digital 19Front L/R, CENTER, Surr L/R Rear PanelInput jacks Balance L/R 12V Trigger OUT A/B/C jacks Remote Controller Controlling the AV ControllerAbout Home Theater Enjoying Home TheaterConnecting the AV Controller Connecting Your SpeakersSpeaker Configuration Connecting a Power Amplifier with RCA InputsConnecting a Power Amplifier with XLR Inputs AV controller MultichannelBalanced XLR cable Using Dipole SpeakersConnecting the Powered Subwoofers Bi-amping the Front Speakers Speaker ImpedanceConnecting a Balanced Audio Source Stereo audio source with Balanced XLR outputAbout AV Connections Connected image with AV componentsAV Cables and Jacks Hdmi cableConnecting Your Components with Hdmi Jack Signal ComponentsAssignment can be changed 45 to Audio return channel ARC functionFront Rear Connecting Your ComponentsJack Signal Components Assignable Connecting Onkyo uComponents How to record the videoAuto Power On Remote ControlConnecting Antenna Connecting the Power CordNorth American European and Asian Models AC InletMonitor Out setting set to Hdmi Main or Hdmi Sub Monitor Out setting set to Both, BothMain or BothSubWhich Connections Should I Use? Video Connection FormatsMonitor Out setting set to Analog For details, refer to Video Resolution ChartDepends on the Audio TV Out setting Audio Connection FormatsStandby indicator Turning On/Off the AV ControllerTurning On Turning OffTOR Setting the Display BrightnessDisplaying Source Information Muting the AV Controller Using the Sleep TimerUsing the Home Menu Using Headphones Using Activities to Start Easy MacrosStarting Components Using Activities Changing the Input DisplayAudyssey MultEQ XT32 Room Correction and Speaker Setup Restoring DefaultUsing Audyssey MultEQ XT32 Turning Off the ComponentsEnter Using a Powered Subwoofer Error MessagesChanging the Speaker Settings Manually Using the Tuner Tuning into Radio StationsListening to the Radio Listening to the RadioPresetting FM/AM Stations Using RDS excluding North American modelsRDS program types PTY Finding Stations by Type PTYListening to Traffic News TP Connecting a Recording Component RecordingRecording Separate AV Sources AV RecordingSelecting Listening Modes Using the Listening ModesListening Mode Buttons About Listening Modes Explanatory NotesInput Source Speaker LayoutListening Modes Resolution Audio Description Input Speaker Source Layout DTS-HD HighDTS-HD Master AudioListening Mode Description Input Speaker Source Layout Modes can be used Neural DigitalMusic *5 Sources such as MP3s and Internet streamsOnkyo-Original DSP Listening Modes Advanced Setup On-screen Setup MenusCommon Procedures in Setup Menu MenuOUT Main Input/Output AssignMonitor Out BD/DVD, VCR/DVR, CBL/SAT, GAME, PC, Tape TV/CD, PHONO, Port ResolutionHdmi Input Component Video Input ` in 1, in 2,Digital Audio Input Analog Audio InputSpeaker Setup Speaker SettingsSpeaker Distance Level CalibrationBGC Equalizer SettingsTHX Audio Setup Dolby Audio AdjustMultiplex/Mono Dolby Volume Volume LevelerHalf Mode PLIIz Height GainSource Setup Dynamic Volume Reference LevelName Edit IntelliVolumeSync Picture Adjust Resolution*2*4 Mosquito NR*2*3*4*6Random NR*2*3*4*6 Block NR*2*3*4*6Listening Mode Preset DTS/DTS-ES/DTS-HDVolume Setup OSD Setup12V Trigger A/B/C Setup MiscellaneousHardware Setup Sirius Settings North American modelsRemote ID Multi ZonePower Control Hdmi ControlRIHDAudio Return Channel TV ControlLock Setup Using the Audio SettingsAudyssey Settings Dolby VolumeSpeaker Levels Music OptimizerAudio Selector Setting the Incoming Digital Signal Fixed ModeRe-EQ Network Requirements Connecting the AV ControllerAbout NET Listening to Other Internet Radio Listening to Internet RadioListening to vTuner Internet Radio Registering Presets*1 Station and Song PresetsPlaying Music Files on a Server Items on the Internet Radio Top MenuWindows Media Player 11 Setup Supported Audio File Formats WMAWAV AACWindows Media Player 12 Setup Remote Playback from Media Server/ Personal ComputerServer Requirements About DlnaNetwork Settings Using Remote PlaybackDhcp List of the device’s contents appears About USBUSB Mass Storage Device Requirements Playing Music Files on a USB DeviceFolder1 02SongTrack2 Artist Album 011234 Connecting Zone Connecting Your Zone 2 SpeakersMulti Zone Zone 2 Video OutputSetting the Multi Zone Connecting Your Zone 3 SpeakersZone 2 Maximum Volume, Zone 3 Maximum Volume Zone 2 Out, Zone 3 OutUsing Zone 2/3 Zone 2 Power On Volume, Zone 3 Power On VolumeControlling Zone 2/3 from the AV controller Zone 2 Component OutControlling Zone 2/3 with the Remote Controller Adjusting the Volume for ZonesAdjusting the Tone and Balance of Zones Muting ZonesUsing the 12V Triggers Trigger OUT B and CUsing a Multiroom Kit with Other Components Using a Multiroom Kit with Zone 2/3Using a Multiroom Kit with a Cabinet Standard Mode control Extended Mode controlPlaying Music Files on the iPod/iPhone Top screen listOnkyo Dock Cable Connecting an Onkyo DockModels sold are different depending on the region Using the Onkyo Dock UP-A1 DockControlling Your iPod RI DockWithout the RI Control With the RI ControlAvailable buttons Onkyo Dock Buttons UP-A1 DockUDock E/rENTER PLAYLISTe/rControlling Other Components Preprogrammed Remote Control CodesLooking up for Remote Control Code Use q/wto select Search by model number Via network, and then press EnterOr if you are not sure about the exact model Select Skip, and then press EnterEntering Remote Control Codes Remote Control Codes for Onkyo Components Connected via uRemote Mode BD/DVD TapeResetting Remote Mode Buttons Resetting the Remote ControllerYou can reset the remote controller to its default settings Controlling Other ComponentsComponents Buttons Cassettetape deckTV VOL q/w CH + Disc +Activities Setup Learning Commands To learn more commands, repeat steps 2Following buttons cannot learn new commands Remote MODE, ALL OFF, MY MOVIE, MY TV, MY Music and ModeUsing Normal Macros Deleting Learning CommandsMaking Macros Running MacrosTroubleshooting Standby indicator flashes redCan’t turn on the AV controller There’s no sound, or it’s very quietThere’s no sound with a certain signal format Can’t select the Pure Audio listening modeAbout DTS signals Only the center speaker produces soundRemote controller doesn’t work There’s no pictureThere’s no picture from a source connected to an Hdmi On-screen menus don’t appearCan’t learn commands from another remote controller Can’t access the server or Internet radioCan’t access the music files on a USB device Stand-by power consumptionSound changes when I connect my headphones Speaker distance cannot be set as requiredDisplay doesn’t work How do I change the language of a multiplex sourceImportant Note Regarding Video Playback Nent Video Monitor OUTSpecifications Amplifier SectionVideo Section Tuner SectionAbout Copyright Protection About HdmiSupported Audio Formats Operations that can be performed with p connection Using an RIHD-compatible TV, Player, or RecorderAbout p-compatible components How to connect and setup Confirm the connecting and settingConfirm the settings Operate with the remote controllerFirmware Update Update procedureUpdating the Firmware via Network Before you startUpdating the Firmware via USB TroubleshootingErrors during update via network Errors during update via USB Video Resolution Chart OutputOnkyo Europe Electronics GmbH Onkyo Europe Electronics GmbH UK Branch