Sound changes when I connect my headphones

■The sound changes when I connect my headphones

When a pair of headphones is connected, the listen- — ing mode is set to Stereo, unless it’s already set to Stereo, Mono, Direct, or Pure Audio.

■The speaker distance cannot be set as required

In some cases, corrected values suitable for home	—
theater use may be set automatically.

■The display doesn’t work

The display is turned off when the Pure Audio listen- — ing mode is selected.

■How do I change the language of a multiplex source

Use the “Multiplex” setting on the “Audio Adjust” 51 menu to select “Main” or “Sub”.

■ The ufunctions don’t work

To use u, you must make an uconnection and an	21
analog audio connection (RCA) between the compo-
nent and AV controller, even if they are connected
digitally.

While Zone 2 or Zone 3 is selected, the ufunc-	—
tions don’t work.

■The functions System On/Auto Power On and Direct Change don’t work for components connected via u

While Zone 2 or Zone 3 is selected, the ufunc-	—
tions don’t work.

■When performing “Audyssey MultEQ® XT32 Room Correction and Speaker Setup”, the measurement fails showing the message “Ambient noise is too high.”.

This can be caused by any malfunction in your	—
speaker unit. Check if the unit produces normal
sounds.

■The following settings can be made for the S-Video and composite video inputs

You must use the buttons on the unit to make these set- tings.

1.While holding down the input selector button for the input source that you want to set, press SETUP.

2.Use e/rto change the setting.

3.Press the input selector button for the input source that you want to set when you’ve finished.

• Video Attenuation

This setting can be made for the BD/DVD, VCR/DVR,

CBL/SAT, GAME, or AUX input.

If you have a games console connected to the composite video input, and the picture isn’t very clear, you can attenuate the gain.

Video ATT:OFF: (default).

Video ATT:ON: Gain reduced by 2dB.

The AV controller contains a microcomputer for signal processing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this happens, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again.

Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by the unit’s malfunction. Before you record important data, make sure that the material will be recorded cor- rectly.

Before disconnecting the power cord from the wall out- let, set the AV controller to Standby.