Power Wash 250™
12.DMX Input Jack – This jack is used to receive an incoming DMX signal or Master/Slave signal.
13.DMX Output Jack – This jack is used to transmit the incoming DMX signal to another DMX fixture, or transmit a Master/Slave signal to the next Power Wash 250B™ in the chain. For best results in DMX or Master/Slave mode terminate this jack if it is the last fixture in the chain. See “Terminator” on page 14.
14.Power Switch – This switch is used to control main power to the fixture.
15.Fuse Holder – This housing stores a 7 amp (3.15 amp 220v) GMA protective fuse. Never defeat the fuse, the fuse is designed to protect the electronics in the event of sever power fluctuations. Always be sure to replace the fuse with an exact match as to the one being replaced, unless otherwise told to do so by an authorized Elation® service technician. Please note; when the fixture orginally ships from the factory we included a 6.3 amp fuse. This fuse may safely be replaced with a 7 amp fuse.
16.Cooling Fan - This fixture is equipped with a high velocity variable fan to aid in the cooling process. This fan is designed to vary its’ velocity at different operating temperatures, to provide better cooling when the fixture reached higher operating temperatures associated with long usage. Be sure to never obstruct the cooling fan during normal usage. Also, be sure to keep this vent clean at all times. A blocked or malfunctioning cooling system may shorten lamp life and fixture reliability.
2.Installation
©Elation Professionals® Los Angeles, Ca. - wwww.ElationLighting.com | - | Page 10 |