Elation Professional 250B user manual Power Wash

Page 31

Power Wash 250™

The lamp orientation and optimization must be adjusted after every lamp change. This procedure centers the lamp in the reflector. Proper optimization will increase lamp life and ensure a bright crisp output. Improper optimization may add a yellow tint to the lamp output and reduce intensity. The minimum deviation amount is 1.0mm. Running the fixture within a lower deviation can cause damage to the lamp and/or lens.

The POWER WASH 250B™ lamp holder is aligned at the factory. However, due to slight imperfections in all lamps, fine adjustments may improve light performance. Please follow this procedure:

6.3.1Strike the lamp (for example in the LAMP menu) and wait a while until full intensity of the lamp.

6.3.2Using either a DMX controller or the control panel on the unit, strike the lamp and focus the light on a flat surface.(beam open, white, no gobo, no effects).

6.3.3Center the hot-spot (the brightest part of the beam) using the 3 adjustment screws. Turn one screw at a time to drag the hot-spot diagonally across the projected image. If you cannot detect a hot-spot, adjust the lamp until the light is even.

6.3.4To reduce a hot-spot, pull the lamp in by turning all three screws clockwise 1/4- turn at a time until the light is evenly distributed.

6.3.5If the light is brighter around the edge than it is in the center, or if light output is low, the lamp is too far back in the reflector. “Push” the lamp out by turning the screws

Attention: Be sure that the minimum distance between the lamp and lens is more then 1.0mm. If it is less then this distance, the lens has higher probability of shattering.

©Elation Professionals® Los Angeles, Ca. - wwww.ElationLighting.com

-

Page 31

Image 31
Contents Software Version Revised 6/2003 Power Wash Table of contents Operation DMX Channel Selection DMX Protocol Service and MaintenanceFuse Replacement Maintenance and Cleaning Color Wheel Oreintation Technical Specification WarrantyMailsupport@ElationLighting.com Power Wash Safety Instructions Features and Functions Power Wash Installation Mounting Securing the Power Wash Connections Power supplyPower Wash Fuse Requirements Level D001 Menu FieldTilt Dfse Feed Eflg ClreTest Program Test Adjust the DMX- Address D001Audio Program Audi Fcol LampRese Time000 255 RtltSpec ManuDisp LaauDlof DmxiFans TempDfse Adju99 + Eflg FeedOperation Stand alone modeMaster/Slave mode DMX control modePower Wash DMX HEX DMX Channel Selection DMX ProtocolLamp OFF Lamp Change Safety GuidelinesLamp Optimization Removing the LampPower Wash Fuse Replacement 1Safety Regulations Maintenance and Cleaning the Power Wash 250BCleaning Frequency rule-of-thumb Page Power Wash Color Wheel Orientation Technical Specification Year 730 Days Limited Warranty Power Wash Power Wash Power Wash