Basic Operation

OPERATION

After you have connected the Firefly™ P350 as described in the P350 Setup section of this manual, you are ready to begin using your P350 LCD notebook projector.

1.Lift the mirror as shown in Figure 6.

2.Press POWER to turn on the P350 LCD notebook projector. The keypanel will light up, the main cooling fans will turn on and the projector lamp will turn on; initially the screen will be blue. After initialization, the Telex logo will appear.

☞NOTE: When the P350 is turned on after a complete cool-down, the lamp will not reach full intensity for approximately one minute of operation.

WARNING! To prevent burns when the P350 is operating, avoid touching the lamp access door and the surrounding area.

3.Turn on the attached computer. The Telex logo will disappear and the computer image will appear.

CAUTION! The cooling fans protect the Firefly™ P350 from heat generated by the projector lamp. Always make sure that the air intake and exhaust are not blocked.

4.Adjust the room lighting for optimum screen viewing. (The projector lamp is automatically turned on when the P350 is turned on.)

5.Adjust the focus control (Figure 11) and keystone control (Figure 12) for best screen image. (You should now leave the projector and lamp on until your presentation begins.)

☞NOTE: The keypanel and on-screen control settings will be the same as they were when the P350 was last used, if ten seconds were allowed to elapse before the P350 was disconnected from the AC wall outlet.

6.To improve the image phase adjustment, display a colorful image on the computer screen and page to the on-screen SYNC control. (It is easier to adjust the Firefly™ P350 with a colorful image.)

7.Turn on your audio source (CD player, wireless microphone, amplifier auxiliary audio output, etc.).

12 User Manual