Telex P350 guide

☞

8. Press VOLUME to adjust the volume of the P350 built-in speakers.

NOTE: If you have an external powered speaker system plugged into the AUDIO OUT jack, turn it on and adjust the volume of that external system. (The level at the AUDIO OUT jack is controlled by VOLUME .)

9.Turn on and play the connected VCR, LaserDisc player, etc.

10.Press SOURCE on the P350 keypanel to select one of the video inputs.

11.To further enhance or change the image on the Firefly™ P350, refer to the Keypanel and Menu Mode On-Screen Control sections of this manual.

NOTE: To maximize the image quality of NTSC, PAL or SECAM video, the On-Screen controls are displayed in a low resolution mode. When video input is displayed, the On-Screen controls will not appear as sharp as when a computer input is displayed.

NOTE: Ten seconds after you make a change, the image enhancements that you have made will be saved. These saved enhancements will be used as the default settings the next time that you activate your P350.

12.When your presentation is complete, press POWER to turn off the projector and lamp.

NOTE: The lamp may be turned off, then on again before it is allowed to cool completely. However, this action will shorten the life of the lamp.

13.After the Firefly™ P350 has cooled and the main cooling fans have stopped, you may unplug the P350 from the AC wall outlet.

NOTE: To use your computer and monitor without disconnecting them from the P350, the P350 must be plugged into an AC wall outlet. The MONITOR jack on the Firefly™ P350 requires power to operate the computer monitor.

NOTE: The projector does not need to be turned on to use the MONITOR jack.

14 User Manual