Onkyo TX-SR506 instruction manual Miscellaneous Setup TX-SR576 only, Volume Setup

Advanced Setup—Continued

Miscellaneous Setup (TX-SR576 only)

This section explains items on the Miscellaneous menu.

1	Press the [RECEIVER] REMOTE
	MODE button, followed by the
	[SETUP] button.

2	Use the Up and Down [ ]/[ ]
	buttons to select
	“6. Miscellaneous,” and then
	press [ENTER].

3	Make sure that “6-1.Vol-
	umeSetup” is shown on the dis-
	play, and then press [ENTER].
4	Use the Up and Down [	]/[	]
	buttons to select an item, and
	use the Left and Right [	]/[	]
	buttons to change it.

The items are explained below.

5	When you’ve finished, press the
	[SETUP] button.
	Setup closes.

Note:

•This procedure can also be performed on the AV receiver by using its [SETUP], [ENTER], and arrow buttons.

Volume Setup

■MaxVolume

With this setting, you can limit the maximum volume.

The Maximum Volume range is Off, 79 to 30.

■PowOn Vol

This setting determines what the volume will be each time the AV receiver is turned on.

The range is Last, Min, 1 to 79, Max.

To use the same volume level as when the AV receiver was last turned off, select Last.

Note:

•The Power On Volume setting cannot be set higher than the Maximum Volume setting.

■HP Level

With this setting, you can offset the headphone volume relative to the main volume. This is useful if your head- phones are too loud or too quiet at the volume setting you usually use when listening through your speakers. The headphone level can be set from –12 dB to +12 dB.

73