Onkyo TX-SR506 instruction manual Hardware Setup TX-SR576 only, Remote Ctrl, Zone

Advanced Setup—Continued

Hardware Setup (TX-SR576 only)

This section explains items on the Hardware menu.

Remote indicator

RECEIVER

ENTER

SETUP

Number buttons

1	Press the [RECEIVER] REMOTE
	MODE button, followed by the
	[SETUP] button.

2	Use the Up and Down [ ]/[ ]
	buttons to select “7. Hardware
	Setup,” and then press [ENTER].

3	Use the Up and Down [ ]/[ ]
	buttons to select an item, and
	then press [ENTER].
	The screen for that item appears.

4	Use the Up and Down [	]/[	]
	buttons to select an item, and
	use the Left and Right [	]/[	]

buttons to change it.

The items are explained below.

5	When you’ve finished, press the
	[SETUP] button.
	Setup closes.

Note:

•This procedure can also be performed on the AV receiver by using its [SETUP], [ENTER], and arrow buttons.

Remote Ctrl

■Remote ID

When several Onkyo components are used in the same room, their remote ID codes may overlap. To differenti- ate the AV receiver from the other components, you can change its remote ID from 1, the default, to 2 or 3.

Note:

•If you do change the AV receiver’s remote ID, be sure to change the remote controller to the same ID (see below), otherwise, you won’t be able to control it with the remote controller.

Changing the Remote Controller’s ID

1	While holding down the
	[RECEIVER] REMOTE MODE but-
	ton, press and hold down the
	[SETUP] button until the Remote
	indicator lights up (about 3 sec-
	onds).
(3 seconds)
2	Use the number buttons to enter
	ID 1, 2, or 3.
	The Remote indicator flashes twice.

Zone 2

See “Zone 2” on page 77.

74