Onkyo TX-SR576, TX-SR506 instruction manual Specifications

Page 95

Specifications—Continued

TX-SR576

Amplifier Section

Rated Output Power

North American:

80 watts minimum continuous power per channel, 8 ohm loads, 2 channels driven from 20Hz to 20kHz, with a maximum total harmonic distortion of 0.08% (FTC)

90 watts minimum continuous power per channel, 8 ohm loads, 2 channels driven at 1kHz, with a maximum total harmonic distortion of 0.7% (FTC)

100 watts minimum continuous power per channel, 6 ohm loads, 2 channels driven at 1kHz, with a maximum total harmonic distortion of 0.1% (FTC)

European:

7 ch 130 W at 6 ohms, 1kHz, 1 ch driven (IEC) Asian and Oceanian:

7 ch 160 W at 6 ohms, 1kHz, 1 ch driven (JEITA)

Dynamic Power

180 W (3, Front)

 

160 W (4, Front)

 

100 W (8, Front)

THD (Total Harmonic

 

Distortion)

0.08% (Power Rated)

Damping Factor

60 (Front, 1kHz, 8)

Input Sensitivity and

200 mV/ 47 k(LINE)

Impedance

Output Level and

200 mV/ 2.2 k(REC OUT)

Impedance

Frequency Response

5Hz–100kHz/ +1 dB–3 dB (direct mode)

Tone Control

±10 dB, 50Hz (BASS)

 

±10 dB, 20kHz (TREBLE)

Signal to Noise Ratio

106 dB (LINE, IHF-A)

Speaker Impedance

 

North American:

6–16

European:

4–16

Asian and Oceanian:

4–16

Video Section

Input Sensitivity/Output

Level and Impedance 1 Vp-p /75(Component and S-Video Y)

0.7Vp-p /75(Component Pb/Cb, Pr/Cr)

0.28Vp-p /75(S-Video C) 1 Vp-p /75(Composite)

Component Video

 

Frequency Response

5Hz – 50MHz, –3 dB

Tuner Section

FM

Tuning Frequency Range

North American: 87.5MHz–107.9MHz

European:87.50MHz–108.00MHz

Asian and Oceanian: 87.50MHz–108.00MHz

AM

Tuning Frequency Range

North American: 530kHz–1710kHz

European:522kHz–1611kHz

Asian and Oceanian: 522kHz–1611kHz

Preset Channel

40

General

Power Supply

 

North American:

AC 120 V, 60Hz

European:

AC 230 V, 50Hz

Asian and Oceanian:

AC 230 V, 50 Hz

Power Consumption

 

North American:

5 A

European:

480 W

Asian and Oceanian:

480 W

Dimensions

435 150 379 mm

(W H D)

 

17-1/8" 5-7/8"14-15/16"

Weight

 

North American:

9.8 kg

21.7lbs. European and Asian: 10.6 kg

23.4 lbs.

Video Inputs

HDMI

IN 1, IN 2, IN 3

Component

IN 1 (DVD), IN 2

Composite

CBL/SAT, VCR/DVR, DVD, AUX

S-Video

CBL/SAT, VCR/DVR, DVD

Video Outputs

HDMI

OUT

Component

OUT

Composite

VCR/DVR (REC OUT),

 

MONITOR OUT

S-Video

VCR/DVR (REC OUT),

 

MONITOR OUT

Audio Inputs

Digital Inputs

COAXIAL (IN 1, IN 2),

 

OPTICAL (IN 1, IN 2),

Analog Inputs

CD, TAPE, CBL/SAT, VCR/DVR,

 

DVD MULTI CH (FRONT, CENTER,

 

SUBWOOFER, SURR, SURR BACK),

 

AUX

Multichannel Inputs

7.1 ch

Audio Outputs

Analog Outputs

TAPE, VCR/DVR, ZONE 2

Subwoofer Pre Outputs

1

Speaker Outputs

ZONE2 R, SURR BACK R, FRONT R,

 

SURR R, CENTER, SURR L, FRONT L,

 

SURR BACK L, ZONE2 L

Phones

PHONES

Control Terminal

MICYes

Specifications and features are subject to change without notice.

95

Image 95
Contents TX-SR506 TX-SR576 Avis Important Safety InstructionsFCC Information for User PrecautionsPower Handling NotesHow to mount the AC plug Supplied AccessoriesPrecautions Make sure you have the following accessoriesContents Connections FeaturesAmplifier ProcessingZone 2 Room Multiroom CapabilityMain Room Front Panel Getting to Know the AV ReceiverDisplay Getting to Know the AV ReceiverRear Panel Zone 2 Line OUT L/R Controlling the AV Receiver Remote ControllerUsing the Remote Controller Remote ControllerInstalling the Batteries Surround back left and right speakers Connecting Your SpeakersEnjoying Home Theater SubwooferSpeaker Configuration Connecting Your SpeakersConnecting a Powered Subwoofer Using Dipole SpeakersStrip about 5/8 Speaker Connection PrecautionsConnecting the Speaker Cables Read the following before connecting your speakersBi-amping Speaker Hookup Bi-amping Front SpeakersAttach the FM antenna, as shown American Model Connecting AntennasConnecting the AM Loop Antenna Connecting the Indoor FM AntennaUsing a TV/FM Antenna Splitter Connecting AntennasConnecting an Outdoor FM Antenna Connecting an Outdoor AM AntennaAV Connection Color Coding Connecting Your ComponentsAbout AV Connections Optical Digital JacksVideo Connection Formats Connecting Your ComponentsConnecting Audio and Video Signals to the AV Receiver Which Connections Should I Use?Hint Connecting a TV or ProjectorVideo Connection Audio ConnectionDVD player Connecting a DVD playerMultichannel analog audio output, see Hooking Up the Multichannel Input VCR or DVR Connecting a VCR or DVR for PlaybackMake the audio connection a Connecting a VCR or DVR for RecordingCBL/SAT in S Supported Audio Formats Connecting Components with HdmiMaking Hdmi Connections About HdmiTip Audio SignalsFor TX-SR506 For TX-SR576Camcorder or console Connecting a Camcorder, Game Console, or Other DeviceMake the video connection a Make the audio connection a Camcorder, game console, etcPhono preamp StepCD player CD or turntableCoaxial CBL/SAT Optical Connecting a Cassette, CDR, MiniDisc, or DAT RecorderIf Your iPod Doesn’t Support Video Connecting an RI DockNot all iPod models output video If Your iPod Supports VideoComponents Connecting Onkyo ComponentsConnecting the Power Cord Some components may not support allUp and Running in a Few Easy Steps Do the automatic speaker setup-this is essentialTurning On the AV Receiver Turning On and StandbyMeasurement Positions First Time SetupAutomatic Speaker Setup Audyssey 2EQ Using Audyssey 2EQError Messages First Time SetupUsing a Powered Subwoofer Speaker SettingsTo Retry the Automatic Speaker Setup Changing the Speaker Settings ManuallyButtons to select 2. Speaker Hdmi Input SetupButtons to select 1-1.HDMI, IN1 Select if the video component is connected to Compo Component Video Input SetupSetup closes Buttons to select 1.InputDigital Input Setup Buttons to select 1-3.Digital Changing the Input DisplayTing you want to change Automatic Audio Input Selection Setup TX-SR576 onlyFor the input selector whose set Start playback on the source component Select a listening mode and enjoyPlaying Your AV Components Basic AV Receiver OperationMuting the AV Receiver Setting the Display BrightnessUsing the Sleep Timer Common FunctionsDisplaying Source Information 7Using HeadphonesSignal format*2 Or sampling Common FunctionsSeconds Specifying the Digital Signal FormatPress and hold the AV receiver’s Digital Input button for aboutTo change the frequency step on the TX-SR506 AM Frequency Step Setup on some modelsListening to the Radio To change the frequency step on the TX-SR576Listening to AM/FM Stations Tuning into AM/FM Radio StationsListening to the Radio For example, to tune to 87.5 FM, press 8, 7 Tuning into Stations by FrequencyDisplaying AM/FM Radio Information Actual display depends on countryDeleting Presets Selecting PresetsThis allows you to search RDS radio stations by type see Using RDS European models onlyWhat is RDS? RDS Program Types PTYFinding Stations by Type PTY Displaying Radio Text RTListening to Traffic News TP Selecting on the AV Receiver Using the Listening ModesSelecting with the Remote Controller Selecting the Listening ModesAnalog and PCM Sources Using the Listening ModesListening Modes Available for Each Source Format Dolby Digital and Dolby Digital Plus Sources Pure Audio DTS SourcesAbout the Listening Modes Onkyo Original DSP Modes Use this mode with any stereo movie e.g., TV, DVD, VHSRecording from Different AV Sources RecordingRecording the Input Source Using the Audio Adjust Settings Adjusting the Listening ModesDolby Digital Settings Adjusting the Listening ModesMultiplex/Mono Settings PLIIx/Neo6 SettingsTone Control Settings Using the Audio SettingsTheater-Dimensional Setting Multichannel Subwoofer SettingSpeaker Levels CinemaFILTERAudyssey Dynamic EQ Music OptimizerListening Mode Presets TX-SR576 only Buttons to select 2.Speaker Advanced SetupSpeaker Setup Setup, and then pressLeft and Right / but- tons to select 2ch or 1ch Advanced SetupCrossover Frequency Use the Down button toSpeaker Distance Double BassRepeat so that the level Turn up the volume so that youCan hear the test tone suffi CientlyPress the Down button, Equalizer SettingsVolume at each frequency can be Setup menu closesIntelliVolume Source Setup TX-SR576 onlyVolume Setup Miscellaneous Setup TX-SR576 onlyZone Hardware Setup TX-SR576 onlyRemote Ctrl AnalogMulti TunerThen press Enter Use the Left and Right Buttons to select Lock Setup TX-SR576 onlyButtons to select 8.Lock Setup Zone Connecting ZoneConnecting Your Zone 2 Speakers Directly to the AV receiver Connecting Your Zone 2 Speakers to an Amp in ZoneButtons to select 7-2.Zone2 Powered Zone 2 Setting3 TX-SR576 onlyControlling Zone 2 from the AV receiver Using ZoneControlling Zone 2 with the Remote Controller Muting Zones Adjusting the Volume of ZonesControlling Other Components Preprogrammed Remote Control CodesEntering Remote Control Codes Controlling Other Components Resetting the Remote ControllerRemote Control Codes for Onkyo Components Connected via Resetting the Remote Mode ButtonsControlling a DVD Player, or DVD Recorder Controlling a VCR or PVR Controlling a Satellite Receiver or Cable Receiver Disc +/- button Controlling a CD Player, CD Recorder, or MD PlayerControlling an RI Dock Controlling a Cassette Recorder ON/STANDBY, TV buttons Controlling a TVTroubleshooting Troubleshooting Can’t control other components Remote controller doesn’t workSound changes when I connect my head- phones There’s no picture from a source connected to an HdmiVideo ATT2 Gain is reduced by 2 dB Video ATT0 defaultVideo Attenuation Tuner Section SpecificationsAmplifier Section Video SectionSpecifications Onkyo Europe UK Office MemoOnkyo Europe Electronics GmbH