Sharp PG-LW2000 See bottom of projector, Void the users authority to operate this equipment

U.S.A. ONLY

U.S.A. ONLY

Before using the projector, please read this operation manual carefully.

IntroductionENGLISH

There are two important reasons for prompt warranty registration of your new SHARP Projector, using the REGISTRATION CARD packed with the projector.

1.WARRANTY

This is to assure that you immediately receive the full benefit of the parts, service and labor warranty applicable to your purchase.

2.CONSUMER PRODUCT SAFETY ACT

To ensure that you will promptly receive any safety notification of inspection, modification, or recall that SHARP may be required to give under the 1972 Consumer Product Safety Act, PLEASE READ CAREFULLY THE IMPORTANT “LIMITED WARRANTY” CLAUSE.

WARNING: High brightness light source. Do not stare into the beam of light, or view

directly. Be especially careful that children do not stare directly into the beam of light.

WARNING: To reduce the risk of fi re or electric shock, do not expose this product to rain or moisture.

See bottom of projector.	The lightning fl ash with arrowhead sym-
CAUTION	bol, within an equilateral triangle, is in-
	tended to alert the user to the presence
RISK OF ELECTRIC SHOCK.	of uninsulated “dangerous voltage”
DO NOT REMOVE SCREWS	within the product's enclosure that may
EXCEPT SPECIFIED USER	be of suffi cient magnitude to constitute
SERVICE SCREW.	a risk or electric shock to persons.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,	The exclamation point within a triangle
DO NOT REMOVE COVER.	is intended to alert the user to the pres-
NO USER-SERVICEABLE PARTS EXCEPT LAMP UNIT.	ence of important operating and main-
REFER SERVICING TO QUALIFIED SERVICE	tenance (servicing) instructions in the
PERSONNEL.
	literature accompanying the product.
WARNING:

This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

WARNING: FCC Regulations state that any unauthorized changes or modifi cations to this equipment not expressly approved by the manufacturer could

void the user's authority to operate this equipment.

The enclosed computer cable must be used with the device. The cable is provided to ensure that the device complies with FCC Class A verifi cation.

U.S.A. ONLY

Introduction

1