Sharp PG-LW2000 appendix Abnormally high Are high Lower than 95F +35ºC

Maintenance indicator			Problem	Cause	Possible Solution
	Normal	Abnormal
Temperature	Off	Red blinks	The internal	• Temperatures	• Use the projector in an
warning		(On)/	temperature is	around the projector	area with a temperature of
indicator		Red on	abnormally high.	are high.	lower than 95°F (+35ºC).
		(Standby)		• Blocked air intake	• Relocate the projector to
					an area with proper
					ventilation. (See page 8.)
				• Cooling fan	• Take the projector to your
				breakdown	nearest Sharp Authorized
				• Internal circuit failure	Projector Dealer or Service
				• Clogged air intake	Center (see page 69) for
					repair.
Lamp	Green on	Red on	The lamp does	• The lamp is shut	• Disconnect the power cord
indicator	(Green		not illuminate.	down abnormally.	from the AC outlet, and
	blinks				then connect it again.
	when the
			Time to change	• Remaining lamp life	• Carefully replace the lamp.
	lamp is
			the lamp.	becomes 5% or less.	(See page 56.)
	warming
					• Take the projector to your
		Red on	The lamp does	• Burnt-out lamp
	up.)
					nearest Sharp Authorized
		(Standby)	not illuminate.	• Lamp circuit failure
					Projector Dealer or Service
					Center (see page 69) for
					repair.
					• Please exercise care when
					replacing the lamp.
					• Securely install the cover.
Power	Green on/	Red blinks	The power	• The lamp unit cover	• If the power indicator blinks
indicator	Red on		indicator blinks in	is open.	in red even when the lamp
	Green		red when the		unit cover are securely
	blinks		projector is on.		installed, contact your
	(Cooling)				nearest Sharp Authorized
					Projector Dealer or Service
					Center (see page 69) for
					advice.

Info

•If the temperature warning indicator illuminates, and the projector enters Standby mode, follow the possible solutions above and then wait until the projector has cooled down completely before plugging in the power cord and turning the power back on. (At least 10 minutes.)

•If the power is turned off for a brief moment due to power outage or some other cause while using the projector, and the power supply recovers immediately after that, the lamp indicator will illuminate in red and the lamp may not be lit. In this case, unplug the power cord from the AC outlet, replace the power cord in the AC outlet and then turn the power on again.

•The cooling fan keeps the internal temperature of the projector constant and this function is controlled automatically. The sound of the cooling fan may change during operation because the fan speed may change and this is not a malfunction.

Appendix

55