Sharp X2 manual Wait Carriage, Wait Cut, Magnification, Cut Mode

Menu options (con’t)

Set mode (con’t)

The following describes the attribute available for each media:

Option	Description	Parameters
Wait Carriage	The Wait Carriage attribute determines the	0 – 30 seconds in 0.1 second
	time delay in seconds that the printer waits	intervals.
	between passes to allow the ink to be
	absorbed by the media.
Wait Cut	The Wait Cut attribute determines the amount of	0 – 30 seconds in .1 second
	time, in seconds, the printer waits after the last	intervals
	pass before performing the cut operation. This
	allows time to let the print image stabilize to
	avoid possible smearing before cutting the print
	from roll.
Magnification	The vertical movement of media between	-0.50% -- and +0.50% in 0.01
	passes of the carriage head is governed by the	intervals.
	number of cycles of the media transport
	system's forward motor. This fine-tunes the
	amount of media vertical movement that is
	associated with each pass of the print heads.
	This value is set at the factory and may vary
	slightly from media to media.
	Note: Changing magnification is only
	recommended to fine tune an image. A setting
	change can affect other modes for different
	images and different media types. True size
	proportions can be compromised.
Cut Mode	Sets automatic media cutting.	NORMAL CUT / NO CUT

Operations 17