Sharp AR-151 operation manual Do not touch the photoconductive drum green portion

Page 11

COPIER INSTALLATION

Be sure to allow the required space around the machine for servicing and proper ventilation.

4" (10 cm)

8"(20 cm)

8"(20 cm)

4" (10 cm)

A small amount of ozone is produced within the copier during operation. The emission level is insufficient to cause any health hazard.

NOTE:

The present recommended long term exposure limit for ozone is 0.1 ppm (0.2 mg/m3) calculated as an 8 hr. time-weighted average concentration.

However, since the small amount that is emitted may have an objectionable odor, it is advisable to place the copier in a ventilated area.

CAUTIONS ON HANDLING

Be careful in handling the copier as follows to maintain the performance of this copier.

Do not drop the copier, subject it to shock or strike it against any object.

Store spare toner cartridges in a cool dry place without removing from the package before use.

If they are exposed to direct sunlight or excessive heat, poor print quality may result.

Do not touch the photoconductive drum (green portion).

Scratches or smudges on the drum will cause dirty copies.

1

Getting started

9

Image 11
Contents AR-151 For Your Records Contents Appendix Conventions used in this manual Getting StartedIntroduction Safety Precautions Main Features Part Names Operation Panel Do not install your copier in areas that are Copier InstallationDo not touch the photoconductive drum green portion Loading Copy Paper Loading Copy Paper Normal Copying Making CopiesNormal Copying Setting a large original Exposure ADJUSTMENT/PHOTO CopyingREDUCTION/ENLARGEMENT/ZOOM To select a zoom ratio To select a preset copy ratioTWO-SIDED Copying TWO-SIDED Copying Special Functions Toner Save ModePreheat mode Auto power shut-off modeSetting the power save modes and auto clear time OFF Displaying Total Number of CopiesToner Cartridge Replacement Supplies and User MaintenanceToner Cartridge Replacement Original table and original cover User MaintenanceToner cartridge life CabinetTransfer charger When copier is not in useMisfeed Removal Copier TROUBLE?Misfeed in the paper feed area Misfeed in the fusing areaMisfeed in the transport area Developer Required Maintenance RequiredProblem Possible cause Solution See TroubleshootingIndication Cause and remedy See Status IndicatorsAutomatic Exposure Adjustment Appendix SpecificationsTypes and sizes of copy paper SuppliesProper storage Optional Equipment System ConfigurationPart names SpecificationsUsing the SPF Single Pass Feeder AR-SP3Misfeed in the SPF Stream feeding modeSingle Pass Feeder AR-SP3 Misfeed removal Sheet Paper Feed Unit AR-DE9Loading copy paper Sheet Paper Feed Unit AR-DE9 Names InstallationMaintenance IndexLoading Special PaperMaterial Safety Data Sheet Section Physical Chemical Characteristics Osha PEL Acgih TLV None required under normal use Memo Page Sharp Electronics Corporation