USER MAINTENANCE
Transfer charger
If copies start becoming streaky or blotchy, the transfer charger may be dirty. Clean the charger using the following procedure.
Turn the power switch off.
Ensure that the bypass tray is open and then open the side cover while pressing the side cover open button.
Take the charger cleaner out by holding the tab.
Set the charger cleaner onto the right end of transfer charger, gently slide the cleaner to the left end, and then remove it. Repeat this operation two or three times.
Slide the charger cleaner from the right end to the left end along the groove of the transfer charger. If the cleaner is stopped on the way, smudges on copies may occur.
Return the charger cleaner to its original position. Close the side cover by pressing the round projections near the side cover open button.
Turn the power switch on.
When copier is not in use
To prevent entry of dust and foreign matter, store the copier as follows.
Remove the power cord and secure the copier using tape (two locations).
4
Supplies and user maintenance
25