Vidikron VP-50 Setting the BNC connectors, To set the BNC Input mode to Comp, BNC Input settings

■OSD ORBITER settings

ON	The position of the menu will be shifted
	by eight dots each time OSD is displayed.
OFF	OSD will be displayed at the same position.

■Restoring the factory defaults settings

Select “FACTORY” under the SETTING 1 menu. Note that this also restores other settings to the factory defaults for Auto Picture.

Setting the BNC connectors

Select whether to set the input of the 5 BNC connectors to RGB and Component.

Example: Set the BNC INPUT mode to “COMP”

Press the MENU button on the remote control to display the

MAIN MENU on the screen, then...

1.Use the and buttons to select “SETTING 1”, then press the MENU button. The “SETTING 1” menu appears.

2.Use the and buttons to select “BNC INPUT”.

3.To set the BNC INPUT mode to “COMP”...

Use the and buttons to select “COMP”. The mode switches as follows each time the or button is pressed:

RGB ↔ COMP

4.Once the setting is completed...

Press the EXIT button to return to the main menu.

To delete the main menu, press the EXIT button once more.

OSD (On Screen Display) Controls

SETTING 2				2 / 3
PREVIOUS PG.
AUTO OFF		:	OFFf
CINEMA MODE		:	ON
PIXL PROTECT		:	OFF
GRAY LEVEL		:	3
S1 / S2		:	OFF
DVI TYPE
NEXT PAGE
SEL.	ADJ.		EXIT EXIT

Information

■BNC INPUT settings

RGB	Use the 5BNC terminals for RGB input.
COMP	Use the 3BNC terminals for Component input.

■Restoring the factory default settings

Select “FACTORY” under the SETTING 1 menu.

Note that this also restores other settings to the factory defaults.

45