Vidikron VP-42 Loop Out Setting, To set the Loop OUT to on, IR Enable settings, Loop OUT settings

OSD (On Screen Display) Controls

4.Once the setting is completed ...

Press the EXIT button to return to the main menu. To delete the main menu, press the EXIT button once more.

Information

■IR ENABLE settings

ON	Enables remote control wireless transmission.
OFF	Disables remote control wireless transmission. Set “OFF”
	to avoid unwanted control from other remote controls.

■Restoring the factory default settings

Select “FACTORY” under the SETTING 1 menu.

Note that this also restores other settings to the factory defaults.

Loop Out Setting

When this feature is set to ON, the received signal will be looped out.

Example: Setting “ON”

Perform the following operations.

Press the MENU button on the remote control to display the MAIN MENU on the screen, then...

1.Use the and buttons to select “SETTING 3”, then press the MENU button. The “SETTING 3” screen appears.

2.Use the and buttons to select “LOOP OUT”.

3.To set the LOOP OUT to “ON”...

Use the and buttons to select “ON”.

The mode switches as follows each time the or button is pressed: OFF ON

SETTING 3			3 / 3
PREVIOUS PG.
TIMER
INPUT SELECT	: LAST
CONTROL LOCK :		ON
IR ENABLE	:	OFF
LOOP OUT	:	ON
ID NUMBER	:	ALL
VIDEO WALL
SEL.	ADJ.	EXIT EXIT

Information

■LOOP OUT settings

ON	The received signal will be looped out via
	PC1 terminal or VIDEO1 terminal.
OFF	The received signal will not loop out.

*Even if LOOP OUT is ON, signals would not be sent out if POWER is being turned off.

■To connect to another display...

See page 68.

■If the RGB/PC1 signal is present at the time the power is switched on...

The RGB/PC1 input will be displayed regardless of the setting of LOOP OUT.

■Restoring the factory default settings

Select “FACTORY” under the SETTING 1 menu. Note that this also restores other settings to the factory defaults.

66