TANDBERG MSE 8350 manual Tandberg

Page 3

Copyright © TANDBERG 2008. All rights reserved. This Getting Started Guide may not be copied, photocopied, translated, reproduced, or converted into any electronic or machine-readable form in whole or in part without prior written approval of TANDBERG.

TANDBERG reserves the right to revise this documentation and to make changes in content from time to time without obligation on the part of TANDBERG to provide notification of such revision or change.

TANDBERG provides this documentation without warranty, term, or condition of any kind, either implied or expressed, including, but not limited to, the implied warranties, terms or conditions of merchantability, satisfactory quality, and fitness for a particular purpose. TANDBERG may make improvements or changes to the product(s) and/or the program(s) described in this documentation at any time.

All other product and company names herein may be trademarks of their respective owners.

61-0018-04 rev 01

TANDBERG

Philip Pedersens vei 20 1366 Lysaker Norway

Telephone: +47 67 125 125

Telefax: +47 67 125 234

Video: +47 67 117 777

E-mail: tandberg@tandberg.com www.tandberg.com

Image 3
Contents Codian IP Gateway Codian IP Gateway Tandberg Table of contents General information About the MSE 8350 IP GW bladePort and LED location LED behavior FDX Step one Install the IP GW blade into the MSE 8000 chassis Installing the IP GW bladeInserting a blade into the chassis Step two Connect to Ethernet Ports a and B Initial configuration Step one Configure Ethernet Ports a and BStep two Configure the default gateway and routes optional Step one Log in to the IP GW blade Configuring the IP GW bladeStep four Configure an operator optional Step three Configure the auto attendant menus optionalStep five Add endpoints and call groups optional Step six Configure the dial planChecking for updates Troubleshooting and technical support information Using the event log to help solve a problemGetting more help 61-0018-04