TANDBERG manual General information, About the MSE 8350 IP GW blade, Port and LED location

Page 5

General information

General information

About the MSE 8350 IP GW blade

The MSE 8350 IP GW blade fits into an MSE 8000 chassis. The IP GW blade is a voice and video gateway that allows calls to be made between pairs of IP endpoints that cannot normally connect directly to each other. A second Ethernet port allows for connections between two completely independent networks of endpoints. A built-in auto attendant and support for manual operators allow easy connection of calls where the endpoint cannot directly address the destination endpoint. The

IP GW blade translates call signalling (for example, between SIP and H.323) and can connect between almost any two endpoints. The IP GW blade can transcode all media to ensure the call takes place.

Port and LED location

Figure 1 shows the position of ports and LEDs on the IP GW blade.

Figure 1: IP GW blade front panel

Compact Flash

Activity LED

Console

Link LED

Console Port

Status LED

Alarm LED

System Load

 

LEDs

 

Ethernet Ports

 

 

Ethernet Port

Power LED

Status LEDs

1

Image 5
Contents Codian IP Gateway Codian IP Gateway Tandberg Table of contents Port and LED location General informationAbout the MSE 8350 IP GW blade LED behavior FDX Step one Install the IP GW blade into the MSE 8000 chassis Installing the IP GW bladeInserting a blade into the chassis Step two Connect to Ethernet Ports a and B Step two Configure the default gateway and routes optional Initial configurationStep one Configure Ethernet Ports a and B Step one Log in to the IP GW blade Configuring the IP GW bladeStep four Configure an operator optional Step three Configure the auto attendant menus optionalStep five Add endpoints and call groups optional Step six Configure the dial planChecking for updates Getting more help Troubleshooting and technical support informationUsing the event log to help solve a problem 61-0018-04