Sharp XG-V10XU Protecting Important Settings with a Password, Setting the Password

Protecting Important Settings with a Password

Projector Remote Control

1, 6

2, 3

4, 5

1.2.3 4.5.6

(GUI) On-screen Display

Setting the Password

A password can be set by the user and used with the keylock level to prevent adjustments to certain settings on the GUI.

•When password is set, you need to enter the password to use “Lamp Mode”, “PRJ Mode”, “Stack Setting”, “Keylock Level”, “Set Inputs”, “RS-232C” and “Set ID No.” menus.

Setting the Password

(Slide the MOUSE/ADJUSTMENT switch	MOUSE ADJ.
on the remote control to the ADJ. position.)

1Press MENU.

2Press ß/© to select “Options (2)”.

3Press ∂/ƒ to select “Password”, and then press

©.

4Enter the new password using ∂/ƒ to select the desired number, and then press © to select the next digit. Continue this procedure for the remaining three digits, and then press ENTER.

5Enter the password again (“Reconfirm”) using ∂/ƒ/ß/©, and then press ENTER.

6To exit from the GUI, press MENU.

•After setting the password, be sure to write it down in a secure location in case you can not remember it.

UsefulNetwork &FeaturesFunction

Changing the Password	Changing the Password
	(Slide the MOUSE/ADJUSTMENT switch
		MOUSE	ADJ.
	on the remote control to the ADJ. position.)
	1 Follow steps 1 to 3 in “Setting the Password”
	above.
	2 Enter the old password using ∂/ƒ/ß/©, and then
	press ENTER.
	3 Enter the new password using ∂/ƒ/ß/©, and
	then press ENTER.
	4 Enter the password again (“Reconfirm”) using
	∂/ƒ/ß/©, and then press ENTER.

E-61