TANDBERG Hub user manual Operator Safety Summary

Page 5

TANDBERG 3G Gateway User Manual

Operator Safety Summary

For your protection, please read these safety instructions completely before operating the equipment and keep this manual for future reference. The information in this summary is intended for operators. Carefully observe all warnings, precautions and instructions both on the apparatus and in the operating instructions.

Warnings

ƒCaution risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.

ƒWater and moisture - Do not operate the equipment under or near water - for example near a bathtub, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool or in areas with high humidity.

ƒCleaning - Unplug the apparatus from the wall outlet before cleaning or polishing. Do not use liquid cleaners or aerosol cleaners. Use a lint-free cloth lightly moistened with water for cleaning the exterior of the apparatus.

ƒVentilation - Do not block any of the ventilation openings of the apparatus. Install in accordance with the installation instructions. Never cover the slots and openings with a cloth or other material. Never install the apparatus near heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

ƒGrounding or Polarization - Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician.

ƒPower-Cord Protection - Route the power cord so as to avoid it being walked on or pinched by items placed upon or against it, paying particular attention to the plugs, receptacles, and the point where the cord exits from the apparatus.

ƒAttachments - Only use attachments as recommended by the manufacturer.

ƒAccessories - Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

ƒLightning - Unplug this apparatus during lightning storms or when unused for long periods of time.

ƒServicing - Do not attempt to service the apparatus yourself as opening or removing covers may expose you to dangerous voltages or other hazards, and will void the warranty. Refer all servicing to qualified service personnel.

ƒDamaged Equipment - Unplug the apparatus from the outlet and refer servicing to qualified personnel under the following conditions:

ƒWhen the power cord or plug is damaged or frayed

ƒIf liquid has been spilled or objects have fallen into the apparatus

ƒIf the apparatus has been exposed to rain or moisture

ƒIf the apparatus has been subjected to excessive shock by being dropped, or the cabinet has been damaged

ƒIf the apparatus fails to operate in accordance with the operating instructions

v

Image 5
Contents 3G Gateway TandbergDisclaimer Trademarks and copyrightIii TANDBERG’s Environmental Policy Environmental IssuesOperator Safety Summary Contact us Table of Contents Introduction Network and Features Rear view Tandberg 3G GatewayFront view 1 3G Gateway Capacity typical scenarios Precautions InstallationUnpacking Installation site preparationsPower cable Connecting cablesIsdn PRI or BRI cables LAN cable3G Gateway Configuration 3G Gateway start-up Accessing the 3G GatewayPage Idle No call is active Active Call Call is active Using the 3G Gateway Call OverviewGW Calls Duration Idle No active call, call has been disconnectedStatus IP/H.323Did Dial from UmtsSequence of Services ConnectingDial from IP ServicesPage PRI Status View System StatusIsdn PRI/BRI Status BRI Status Page IP Address Shows the IP address of the 3G Gateway 2 H.323 StatusSystem Information Available Resources Isdn PRI/BRI Configuration Configure the 3G GatewayPRI Configuration PRI ProtocolBearer capabilities BRI configurationLow Channel BRI ProtocolBearer capabilities General SS7 ConfigurationTrunks Link setsExample1 RestartExample2 Page Page IP Address Assignment IP ConfigurationAddress Subnet MaskEthernet Speed Auto Date and Time Settings10Half 10FullGatekeeper IP Address H.323 ConfigurationAuthentication ID, Password Authentication ModeSIP Configuration Video Portal Systems Video Portal ConfigurationVideo Portal Settings Snmp Mode Snmp ConfigurationSnmp Community name System contactSnmp Trap Host 1, 2 System locationPassword Miscellaneous ConfigurationConfiguration Services Phonebook settingsExternal Manager settings Software Upgrade Page Page Service type Services ConfigurationDescription Net type from10.1 IVR Example 1 Number-plan mapping ExamplesBackspace Example4 H323 to SIP Example 2 HotlineExample3 SIP to H323 Appendices Appendix 1 Declaration of Conformity State 1 menu navigation, Display current menu item Appendix 3 using the front panel LCD keysState 7 Choose Configuration option Technical Specifications Index Tandberg Gateway Index Snmp