Runco VX-2i manual Installation, Remote Control

Page 21

3. Installation

To install batteries in the remote control, press up on the battery cover retainer clip and lift off the cover. Install the two AAA batteries with the correct polarity and then replace the cover.

•Make sure that the battery polarities are correct when installing the batteries.

•Do not mix an old battery with a new one or different types of batteries.

•If you will not use the remote control for a long time, remove the batteries to avoid damage from battery leakage.

•Make sure that there is nothing obstructing the infrared beam between the remote control and the IR receiver on the projector.

•If the effective range of the remote control decreases, or it stops working, replace the batteries with new ones.

•The remote control may fail to operate if the infrared remote sensor is exposed to bright sunlight or fluorescent lighting.

•Ambient conditions may possibly impede the operation of the remote control. If this happens, point the remote control at the projector, and repeat the operation.

•The Ø icon appears on the screen when a button for an unavailable function is pressed.

3.1

Remote Control

Notes on Batteries

Notes on Remote Control Operation

Runco VX-2i Owner’s Operating Manual

11

Image 21

Contents VX-2i Page For Projectors, Video Processors and Controllers TWO Year Limited WarrantyEffective Warranty Date Runco INTERNATIONAL, INC Safety Precautions Table of Contents Specifications Maintenance and TroubleshootingOperation Serial CommunicationsList of Figures List of Figures About This Manual IntroductionIf you need Turn to Using This ManualKey Features and Benefits Description, Features and BenefitsOptional Accessories VX-2i at a Glance Controls and FunctionsHD1 / HD2 Analog BNC connectors Component Video RCA connectorsVideo 1 / S-VIDEO Volt 800 mA Trigger OutputsPower Input 100 to 240 VAC Connect the VX-2i to power here VX-2i Remote ControlCursor Keys On / OFFVideo Comp ComponentANA Anamorphic 3 For 169 DVDs 4X3 Standard 43 Aspect Ratio Selection ButtonsLetbox Letterbox Wide VirtualWideRemote Control InstallationStep Procedure For Details, Refer to Quick SetupInstallation Type Installation ConsiderationsFlat vs. Curved Screens Ambient Light Other ConsiderationsThrow Distance Lens Option Note Throw Dist Screen Width Minimum Maximum Throw Ratio Throw Distance RangeVertical and Horizontal PositionLens Shift Vertical Lens Shift Angle Adjusting the ProjectionMounting Folded OpticsConnecting the VX-2i to Connector Panel AccessConnections to VX-2iDigital DTV RGB Connections Digital DTV RGB Connections See FigureAnalog RGB Connections Analog Computer RGB Connections See Figure10. Composite, S-Video and Component Video Connections Composite/S-Video/Component Video Connections See FigureRS-232 Controller Connecting 12-VoltConnection Trigger Outputs toTurning on the Power Adjusting the Picture OrientationOperation Lens Adjustments Using the On-Screen MenusFocus Zoom Shift Service ISF PresetsInput Source Aspect RatioInput Source Main MenuAspect Ratio Input Source Composite Video Component SDRemote Aspect Ratio Control Description Key Aspect Ratio SettingsPicture Brightness Contrast Color Tint Sharpness PictureTypical Gray Bar Pattern for Adjusting Contrast Gray Yellow Cyan Green Magenta Red Blue Input Position Left/Right Up/Down Width Height Overscan Input PositionInformation ISF PresetsCalibration Should be used by ISF-certified technicians onlyOperation Service Tip Operation Maintenance and Troubleshooting Lamp Replacement Troubleshooting TipsSymptom Possible Causes Solution Maintenance and Troubleshooting Serial Command Syntax RS-232 Connection and Port ConfigurationCommand Parameter Value Description Min/max Stored? Serial CommunicationsSerial Communications Night YES SHARPNESS? VX-2i Specifications SpecificationsIndustry-Standard Specifications Home Theater Calibration SpecificationsPower Requirements DimensionsSpecifications are subject to change without notice Limited WarrantyVX-2i Dimensions VX-2i DimensionsPage Runco CL-810 Owner’s Operating Manual