
Selecting A Resolution (Scan Rate)
To select a scan rate, first determine which type of display will be used with the
(see 'Fixed pixel displays' or 'CRT displays' below). If the display is a FIXED PIXEL display, you'll want to use one of the FIXED PIXEL scan rates. If using a CRT projector, you'll want to use one of the CRT scan rates.
To select a resolution, follow this procedure:
·Press MENU and ensure 'INSTALLATION' is on the bottom of the menu. If it's not, enable the INSTALLATION menu using the procedures on page 17.
·Using the up or down arrow buttons, highlight INSTALLATION and press ENTER.
·Once the INSTALLATION menu is
·Note that at the top of the SCAN RATE menu that it will say either "PROGRESSIVE" or
"SCAN
·Next, highlight the desired SCAN RATE and press ENTER. The
Runco recommends that you ensure your display device produces an image before confirming the scan rate. If it does not, allow the processor to revert to its previous scan rate and consult the owner's manual of your display to see what it's scan rate or resolution capabilities are.
SCAN RATE menus:
Note that the arrow indicates the currently selected scan rate (854 x 480, in this example):
PFP-7
PFP-11
Fixed Pixel Resolutions
4:3 Device 800 x 600 1024 x 768
16:9 Device
>854 x 480
1280 x 720
1280 x 768
1024 x 1024 More...
CRT Scan Rates
Progressive
480p
540p
600p
720p
More...
Fixed Pixel - 4:3 Device
4:3 Device
800 x 600
1024 x 768
1280 x 1024
1366 x 1024
16:9 Device
>854 x 480
1280 x 720
1280 x 768
1366 x 768
1024 x 1024
More...
CRT Scan Rates
Progressive
480p
540p
600p
720p
More...
19