Runco Vivix Pixel for Pixel, PFP-7, PFP-11 manual Menu Description and Navigation, Main Menu

Page 15

MENU DESCRIPTION AND NAVIGATION

Main Menu

MAIN MENU

>COMPOSITE S-VIDEO COMPONENT PASS THROUGH

ASPECT RATIO INSTALLATION

Source selection and picture quality adjustments

Aspect ratio selection

See "installation" section

When the MENU button is pressed on either the remote control or the front panel, the main menu will appear on-screen. An example of the main menu is shown above.

The active source is indicated by an arrow to the left of the source; note that in the example above, Composite is the current source.

To select a source via the main menu, press either the up or down buttons on the remote or front panel and highlight the desired source, and press ENTER. Otherwise, you may select a source by pressing either the left or right arrow buttons (on the remote or front panel) when no menus are on-screen, or by pressing one of the direct access buttons on the remote control (recommended; see page 10).

If pass-through is selected, note that no on-screen menus will be displayed since the signal is simply being 'looped' directly to the output. When pass-through is the selected source, pressing MENU will automatically select the last selected input before Pass-through was selected. If you wish to choose another source, Runco recommends using the direct access buttons to select the desired source as opposed to pressing MENU.

Aspect Ratio provides selection of one of three aspect ratios: Anamorphic, Letterbox or standard 4:3. To select an aspect ratio via the main menu, press either the up and down buttons on the remote or front panel, highlight ASPECT RATIO and press ENTER. The aspect ratio menu will then appear with the three choices; highlight the desired aspect ratio with the up or down buttons and press ENTER. Otherwise, you may select an aspect ratio by pressing either the up or down arrow buttons (on the remote or front panel) when no menus are on-screen, or by pressing one of the direct access buttons on the remote control (recommended; see page 10).

Installation is where the scan rate and sync types can be adjusted, as well as screen types, 'side bar' levels, image shift and blanking controls. A full description of this menu is on page 18.

NOTE: If INSTALLATION does not appear on the main menu, see page 18 for an explanation on how to access the Installation menu.

14

Image 15
Contents PFP-7/PFP-11 PFP-7/PFP-11 Page Contents Remarque Safety Tips DOC compliance NoticeDOC avis de conformation Features and Benefits IntroductionGeneral Description Front Panel Front and Rear Panel DescriptionsRGB Video Output Video Inputs Rear PanelPower Input Power Button Remote Control DescriptionConnection Examples Quick SET-UP GuideGetting Started Compatibility Overall Functional DescriptionMain Menu Menu Description and NavigationWhite Yellow Cyan Green Magenta Red Blue Picture Quality AdjustmentsPage Installation Menu Screen Type Scan Rate/ResolutionTo select a resolution, follow this procedure Selecting a Resolution Scan RateFixed Pixel Displays Output Format Menu Output Format SyncSide Bar Level Image Shift Runco PFP-7 Side Bar Level 013System Reset To reset your PFP-7/PFP-11, follow this procedureBlanking Aspect Ratios Active image area Actual screen area Blanked cut off Areas Dimensions TopSide Other notes RS-232 CommunicationsDescription RS-232 CommandsStore YES Specifications Page RUMA-006200 rev