To use side bar level, it will be necessary to 'unblank' the left and right sides of the image. Please follow this procedure to set side bar level:
·Ensure an active source is displayed on the screen or display.
·Select the standard (4:3) aspect ratio. NOTE: Ensure 16:9 screen is selected in the INSTALLATION menu.
·Access the INSTALLATION menu, highlight BLANKING and press ENTER.
·Highlight LEFT with the up or down arrow buttons, then press and hold the left arrow button. You will begin to see the sidebar slowly appear on the left side.
Continue holding down the left arrow button until the left sidebar fills the left side of the screen.
·When the left side is fully unblanked, perform the same procedure for the right side.
·Once both sides are fully unblanked, you can set the level of the sidebars. Highlight SIDE BAR LEVEL on the INSTALLATION menu and press ENTER. Use the up arrow button to increase the illumination of the side bars, or the down arrow to decrease their illumination. NOTE: It is recommended that an active image be displayed on- screen, and the level of the sidebars be set to match the average amount of illumina tion on the 4:3 portion of the image.
Runco PFP-7
Side Bar Level | 013 |
Image Shift
IMAGE SHIFT moves the entire image up, down, left or right. If the image is slightly
While using IMAGE SHIFT will not cause any problems with your display, it is possible to use too much image shift, which could cause the image to shake or disappear. Therefore, Runco recommends that image shift be done with the display device itself whenever possible.
Image Shift
Hstart: 268
Vstart: 131
23