Runco PFP-11, Vivix Pixel for Pixel, PFP-7 manual RS-232 Communications, Other notes

Page 29

RS-232 COMMUNICATIONS

General Information

 

Baud rate: 9600 (fixed)

 

Bits: 8

 

No Parity

 

All protocol in ASCII format

 

RS-232 input connector pin numbers:

TxD= Pin# 2

 

RxD= Pin# 3

 

GnD= Pin# 5

Command format (single command): command value (i.e. brightness 30).

NOTE: A space (not an underscore) or comma may be used between the command and its value.

Command string format: command,command value, command etc. (i.e. COMPOSITE,BRIGHTNESS 30,ANAMORPHIC)

NOTE: In between commands, a comma must be used; a comma or space may be used in between a command and its value.

Other notes:

·For command strings, a maximum of 255 characters can be used in a single string.

·If it is necessary to input multiple commands, they should all be together in a single string. Inputting commands one at a time requires a 15 second delay between commands, as the information is stored into non-volatile memory after each command.

·For values not automatically stored (see next paragraph), the command "!STORE" must be sent in order for the PFP-7/PFP-11to keep the settings. Otherwise, the values will be considered temporary and will revert to their stored settings upon source change or power-up.

·The "Value stored" column refers to a command that is either automatically stored or if it must be manually stored with the "!STORE" command.

·PARAMETER min/max refers to a function's minimum and maximum value range. Inputting values above or below their range may cause unpredictable (but not fatal) results.

28

Image 29
Contents PFP-7/PFP-11 PFP-7/PFP-11 Page Contents Remarque DOC avis de conformation Safety TipsDOC compliance Notice General Description Features and BenefitsIntroduction Front Panel Front and Rear Panel DescriptionsRGB Video Output Video Inputs Rear PanelPower Input Power Button Remote Control DescriptionConnection Examples Quick SET-UP GuideGetting Started Compatibility Overall Functional DescriptionMain Menu Menu Description and NavigationWhite Yellow Cyan Green Magenta Red Blue Picture Quality AdjustmentsPage Installation Menu Screen Type Scan Rate/ResolutionTo select a resolution, follow this procedure Selecting a Resolution Scan RateFixed Pixel Displays Output Format Menu Output Format SyncSide Bar Level Image Shift Runco PFP-7 Side Bar Level 013Blanking System ResetTo reset your PFP-7/PFP-11, follow this procedure Aspect Ratios Active image area Actual screen area Blanked cut off Areas Side DimensionsTop Other notes RS-232 CommunicationsDescription RS-232 CommandsStore YES Specifications Page RUMA-006200 rev