Runco CL-510LT manual Installation, Remote Control, Projector, Connect the Power Cord

Page 12

Runco CL-510/ CL-510LT User’s Manual

2. Installation

Remote Control

Push forward on the tap and lift to open the cover. Install the two AAA batteries with the correct polarity, then close the cover.

Notes on Batteries

■Make sure that the battery polarities are correct when installing the batteries.

■Do not mix an old battery with a new one or different types of batteries.

■If you will not use the remote control for a long time, remove the batteries to avoid damage from battery leakage.

Notes on Remote Control Operation

■Make sure that there is nothing obstructing the infrared beam between the remote control and the IR receiver on the projector.

■The useable range is between 3m/ 9.8 feet (from the front of the projector) and 4m/ 13.1 feet (from the top of the projector) within a 30 degree horizontal angle and 15 degree vertical angle.

Projector

❚Connect the Power Cord

Plug the supplied power cord into the AC inlet in the rear of this unit. (AC 100V ~ 240V)

Turn on the main power switch on the rear of this unit (next to the AC inlet). The POWER LED will light up in orange. Press ON key on the remote control for ONE second to turn on the unit.

2. Installation 9

Image 12

Contents CL-510 / CL-510LT What is Covered Under the Terms of this Warranty What is not Covered Under the Terms of this WarrantyEffective Warranty Date RIGHTS, Limits and ExclusionsImportant Warranty Registration To Obtain SERVICE, Contact Your Runco DealerAdditional Information Runco CL-510/ CL-510LT Video Projector User’s Manual Table of Contents Features OverviewProjector Exterior View Front / Upper SideRear / Bottom Side Controls and Functions Control PanelLamp LED Zoom RingConnector Panel DVI/ HdcpRemote Control OFFActive PIP+PIP RGB HDInstallation Remote ControlConnect the Power Cord ProjectorAdjust the Lens Zoom/Focus ring Adjust the heightInstallation For CL-510 With 1.75 2.00 Lens Screen H x WThrow Distance Vertical OffsetThrow Distance Chart For CL-510 With 1.75 2.00 Lens Screen Hight Screen Width Min TD Max TD Vertical OffsetInstallation For CL-510LT With 2.30 3.00 Lens Throw Distance Chart For CL-510LT With 2.30 3.00 Lens Connecting Connecting Video InputsVideo / S-Video / Component Interlaced Video Progressive Component DTV Y/PB/PR Rgbhv DTV RGBConnecting a Computer DVI/ Hdcp Turning on the Power Zoom/ FocusingBasic Operation Selecting Video MemoryDirect Picture Adjust Menu Bypass Setting MenuSelecting Aspect Ratio Selecting Input Source PIP/ PBP functionTurning off the Power Using the Menu MenuMain Menu Picture Quality Adjustments Aspect RatioScreens Options Setup White Balance To adjust grey scale Additional Information Replace the Lamp Contact your Runco DealerTroubleshooting Problem Possible Cause RemedySpecifications CL-510/ CL-510LT SpecificationsAnsi Lumen specification Csms Home Theater Calibration Ansi Lumen SpecificationCsms Home Theater Calibration foot-Lambert fL Specification Dimensions RS-232 Setup RS-232C Control Codes PC Out AdapterRUMA-010300 rev