Setup

Runco CL-510/ CL-510LT User’s Manual

Lamp Hours: To check for total time of lamp usage.

OSD Position: To adjust horizontal and vertical positions of OSD.

PC & HD Adj.: The following settings are only available with a PC or DTV RGB signal. There is no position adjustment when using DVI-D signal.

■AUTO: Adjusts the phase, frequency and position automatically.

■FREQ.: Adjusts the frequency of the signal.

■PHASE: Adjusts the phase of the input signal.

■H. POS.: Adjusts the horizontal position of the image.

■V. POS.: Adjusts the vertical position of the image.

Runco CL-510

>Video S-Video Component Component HD RGB HD DVI-I

-----------------------

Aspect Ratio

Options Setup

Setup

>Keystone Blue Image White Balance Reset Lamp Timer Background Color

The Setup menu is passcode protected and for use by Runco personnel only. Many of the adjustments available in this section are intended for use by trained service personnel only. If you are having difficulty with one of these items, please contact your Runco Dealer for service.

All items below which are printed in italic are intended for service personnel only. Non-italic items can be modified by the projector owner.

The CL-510 has four memory settings for color temperature. Three of these settings are factory set to default as follows:

Temp 1 -- 5400 kelvin

Temp 2 -- 6500 kelvin

Temp 3 -- 7500 kelvin

The Temp 4 memory is installer adjustable and can be used to create custom settings. A passcode must be entered in order to change this setting. There are nine adjustable "white balance" parameters available for the Temp 4 setting. Once the desired adjustments have been entered, selecting "store" will save these custom settings into the "Temp 4" memory position.

Keystone: Corrects the trapezoidal distortion as a result of the angle of projection (-12° ~ +12°). This can correct for up to +/- 12 degrees of offset.

Blue Image: This mutes the red and green.

5. Menu 25