Runco CL-510LT manual Options

Page 27

Runco CL-510/ CL-510LT User’s Manual

■4 x 3: The input signal will be scaled to fit in the center of the 16:9 screen.

Active

Image Area

■LETTERBOX: The image in the Letterbox mode will be stretched vertically, and the top and bottom portion 'blanked off'. This ratio is best suited for LaserDisc movies or non-anamorphic DVD's.

Active Image Area

■VIRTUAL WIDE: A 4:3 image is transformed into a 16x9 image.

Options

Runco CL-510

>Video S-Video Component Component HD RGB HD DVI-I

-----------------------

Aspect Ratio

Options

Set Up

Press Enter on selected feature to open the adjustment menu.

Options

>Reset Adjustments Language Picture Orientation Logo Light

Sleep Timer Lamp Hours OSD Position PC & HD Adj.

Reset Adjustments: Use this function to reset all values of the current source back to factory default.

Language: There are 4 different menu languages available: English, Spanish, French and German.

Picture Orientation: The projector can be installed on a ceiling or in a rear screen configuration with one or more

mirrors. There are four settings: FLOOR FRONT, CEILING FRONT, FLOOR REAR, and CEILING REAR.

Logo Light: To turn on or off projector logo light.

Sleep Timer: To setup auto off timer. The setting timer is from 10 minutes to 3 hours.

245. Menu

Image 27

Contents CL-510 / CL-510LT RIGHTS, Limits and Exclusions What is Covered Under the Terms of this WarrantyWhat is not Covered Under the Terms of this Warranty Effective Warranty DateImportant Warranty Registration To Obtain SERVICE, Contact Your Runco DealerAdditional Information Runco CL-510/ CL-510LT Video Projector User’s Manual Table of Contents Overview FeaturesProjector Exterior View Front / Upper SideRear / Bottom Side Zoom Ring Controls and FunctionsControl Panel Lamp LEDDVI/ Hdcp Connector PanelOFF Remote ControlRGB HD ActivePIP+ PIPProjector InstallationRemote Control Connect the Power CordAdjust the height Adjust the Lens Zoom/Focus ringVertical Offset Installation For CL-510 With 1.75 2.00 LensScreen H x W Throw DistanceScreen Hight Screen Width Min TD Max TD Vertical Offset Throw Distance Chart For CL-510 With 1.75 2.00 LensInstallation For CL-510LT With 2.30 3.00 Lens Throw Distance Chart For CL-510LT With 2.30 3.00 Lens Connecting Connecting Video InputsVideo / S-Video / Component Interlaced Video Rgbhv DTV RGB Progressive Component DTV Y/PB/PRConnecting a Computer DVI/ Hdcp Selecting Video Memory Turning on the PowerZoom/ Focusing Basic OperationDirect Picture Adjust Menu Bypass Setting MenuSelecting Aspect Ratio PIP/ PBP function Selecting Input SourceTurning off the Power Using the Menu MenuMain Menu Picture Quality Adjustments Aspect RatioScreens Options Setup White Balance To adjust grey scale Replace the Lamp Contact your Runco Dealer Additional InformationProblem Possible Cause Remedy TroubleshootingCL-510/ CL-510LT Specifications SpecificationsAnsi Lumen specification Csms Home Theater Calibration Ansi Lumen SpecificationCsms Home Theater Calibration foot-Lambert fL Specification Dimensions RS-232C Control Codes PC Out Adapter RS-232 SetupRUMA-010300 rev