Runco CL-510LT manual Controls and Functions, Control Panel, Lamp LED, Zoom Ring, Focus Ring

Page 8

Runco CL-510/ CL-510LT User’s Manual

Controls and Functions

❚Control Panel

1.POWER LED Indicate power status

■Orange when the AC power cord is plugged into the wall outlet (standby mode). Once in the standby mode, you can turn on the projector by pressing the ON key on the remote control for ONE second.

■Green when the power is turned on (operational mode).

■Flashing Orange for the first 45 seconds after power-up indicating that the lamp is warming up.

■Flashing Green for 90 seconds after the projector is powered off indicating that the lamp is cooling down.

2.LAMP LED

Indicates the status of lamp

■Red when the lamp has developed a problem. Please contact your Runco Dealer for assistance.

3.ZOOM RING

Adjust the size of the image

■Rotate right to enlarge the image, and rotate left to make the image smaller.

4.FOCUS RING

Adjust the focus of the image

■Rotate the focus ring right or left to focus the image.

1. Overview 5

Image 8

Contents CL-510 / CL-510LT What is Covered Under the Terms of this Warranty What is not Covered Under the Terms of this WarrantyEffective Warranty Date RIGHTS, Limits and ExclusionsAdditional Information Important Warranty RegistrationTo Obtain SERVICE, Contact Your Runco Dealer Runco CL-510/ CL-510LT Video Projector User’s Manual Table of Contents Features OverviewRear / Bottom Side Projector Exterior ViewFront / Upper Side Controls and Functions Control PanelLamp LED Zoom RingConnector Panel DVI/ HdcpRemote Control OFFActive PIP+PIP RGB HDInstallation Remote ControlConnect the Power Cord ProjectorAdjust the Lens Zoom/Focus ring Adjust the heightInstallation For CL-510 With 1.75 2.00 Lens Screen H x WThrow Distance Vertical OffsetThrow Distance Chart For CL-510 With 1.75 2.00 Lens Screen Hight Screen Width Min TD Max TD Vertical OffsetInstallation For CL-510LT With 2.30 3.00 Lens Throw Distance Chart For CL-510LT With 2.30 3.00 Lens Video / S-Video / Component Interlaced Video ConnectingConnecting Video Inputs Progressive Component DTV Y/PB/PR Rgbhv DTV RGBConnecting a Computer DVI/ Hdcp Turning on the Power Zoom/ FocusingBasic Operation Selecting Video MemorySelecting Aspect Ratio Direct Picture Adjust Menu BypassSetting Menu Selecting Input Source PIP/ PBP functionTurning off the Power Main Menu Using the MenuMenu Screens Picture Quality AdjustmentsAspect Ratio Options Setup White Balance To adjust grey scale Additional Information Replace the Lamp Contact your Runco DealerTroubleshooting Problem Possible Cause RemedySpecifications CL-510/ CL-510LT SpecificationsCsms Home Theater Calibration foot-Lambert fL Specification Ansi Lumen specificationCsms Home Theater Calibration Ansi Lumen Specification Dimensions RS-232 Setup RS-232C Control Codes PC Out AdapterRUMA-010300 rev