Runco CL-510 manual Basic Operation, Turning on the Power, Zoom/ Focusing, Selecting Video Memory

Page 21

Runco CL-510/ CL-510LT User’s Manual

4. Basic Operation

Turning on the Power

■The Power LED lights orange when power is applied and the power switch is turned on.

■Press and hold the ON key on the remote control for ONE second to turn on the unit. The POWER LED will blink orange during warm up period, then light solid green.

■" Searching…." will be displayed on the screen before the projector identifies the input signal. This message will remain on the screen until a valid signal is detected.

■If an incompatible input signal exceeds the range of the projector a "Not supportive timing" message will be displayed on the screen. This message will remain on the screen until you change the input signal.

Zoom/ Focusing

■Adjust the projection image size you need with the zoom ring on the lens. To focus the image, rotate the focus ring on the lens.

Zoom out

Focus

Zoom in

Selecting Video Memory

■Press M1, M2, M3 buttons to recall settings in the memory.

■Press Default to select the default setting.

184. Basic Operation

Image 21

Contents CL-510 / CL-510LT What is not Covered Under the Terms of this Warranty What is Covered Under the Terms of this WarrantyEffective Warranty Date RIGHTS, Limits and ExclusionsImportant Warranty Registration To Obtain SERVICE, Contact Your Runco DealerAdditional Information Runco CL-510/ CL-510LT Video Projector User’s Manual Table of Contents Overview FeaturesProjector Exterior View Front / Upper SideRear / Bottom Side Control Panel Controls and FunctionsLamp LED Zoom RingDVI/ Hdcp Connector PanelOFF Remote ControlPIP+ ActivePIP RGB HDRemote Control InstallationConnect the Power Cord ProjectorAdjust the height Adjust the Lens Zoom/Focus ringScreen H x W Installation For CL-510 With 1.75 2.00 LensThrow Distance Vertical OffsetScreen Hight Screen Width Min TD Max TD Vertical Offset Throw Distance Chart For CL-510 With 1.75 2.00 LensInstallation For CL-510LT With 2.30 3.00 Lens Throw Distance Chart For CL-510LT With 2.30 3.00 Lens Connecting Connecting Video InputsVideo / S-Video / Component Interlaced Video Rgbhv DTV RGB Progressive Component DTV Y/PB/PRConnecting a Computer DVI/ Hdcp Zoom/ Focusing Turning on the PowerBasic Operation Selecting Video MemoryDirect Picture Adjust Menu Bypass Setting MenuSelecting Aspect Ratio PIP/ PBP function Selecting Input SourceTurning off the Power Using the Menu MenuMain Menu Picture Quality Adjustments Aspect RatioScreens Options Setup White Balance To adjust grey scale Replace the Lamp Contact your Runco Dealer Additional InformationProblem Possible Cause Remedy TroubleshootingCL-510/ CL-510LT Specifications SpecificationsAnsi Lumen specification Csms Home Theater Calibration Ansi Lumen SpecificationCsms Home Theater Calibration foot-Lambert fL Specification Dimensions RS-232C Control Codes PC Out Adapter RS-232 SetupRUMA-010300 rev