Installation
3. Installation
To install batteries in the remote control:
1.Slide the battery compartment cover in the direction of the arrow to remove it.
2.Install two AA batteries with the correct polarity.
3.Replace the cover.
3.1
Remote Control
1. | 2. |
3. |
• Make sure that the battery polarities are correct when installing the batteries. | Notes on Batteries |
•Do not mix an old battery with a new one or different types of batteries.
•If you will not use the remote control for a long time, remove the batteries to avoid damage from battery leakage.
• In most situations, you can simply point the remote control at the screen which will | Notes on Remote Control |
reflect the IR signal from the remote back toward the IR receiver on the projector. In | Operation |
some cases, however, ambient conditions may prevent this. If so, point the remote |
|
control at the projector and try again. |
|
•If the effective range of the remote control decreases, or it stops working, replace the batteries with new ones.
•The remote control may fail to operate if the infrared remote sensor is exposed to bright sunlight or fluorescent lighting.
Runco | 13 |