MESSAGES, WARNINGS, AND FAILURES
INPUT 01
Fh= 15.6 kHz
Fv= 050 Hz
SOURCE 01
enter password
X X X X
text on
text off
PROJECTOR ADDRESS:
003
PROJECTOR ADDRESS:
003
WARNING:
invalid key entry
When selecting a new source, information about this source will be displayed on the screen. Source number, horizontal and vertical frequencies of the dis- played source.
Announcement of the selected source.
Message to enter your password. Password contains 4 digits.
These messages will be dis- played on the screen when push- ing the TEXT key.
Text ON : the ‘bar scale indica- tion’ will be enabled during the change of an analog control in the ‘operational mode’ + all warnings and failures will be dis- played.
Text OFF : the ‘bar scale indica- tion’ will be disabled during the change of an analog control in the ‘operational mode’ + all warnings and failures will not be displayed.
Indication of the projector address when activating the ‘ADDRESS’ button on the RCU with a pencil or other small object.
The input is a valid input but the source is not connected to the input terminals or the input source is switched off.
When a wrong key is pressed on the RCU.
WARNING:
invalid key entry
WARNING:
end of ad- just range
WARNING: input no longer available
WARNING: invalid
frequency input
table is deleted
FAILURE
I2C error addr.: 7FH3
FAILURE short circuit on 12C bus
Message when the entered pass- word is wrong.
End of adjustment range.
Message will be displayed when the input source is no longer available. The following mes- sage then appears: ‘check input signal or select new source’.
The entered frequency or applied frequency of the source is out of the projector’s range
Message to inform that selected table is deleted. This message will be followed by ‘confirm message’, on which the user has to answer.
Hardware failure. Call a quali- fied service technician for repair.
Hardware failure. Call a quali- fied service technician for repair.