Runco DTV-873 manual Connecting a RGB Analog source, Rgbs or RGsB input selection

Connections

Connecting a RGB Analog source.

RS232 IN	RS232 OUT	IR	COMM PORT REMOTE	R	G(s)	B	H	V	VIDEO S - VIDEO This device complies with part 15 of
									the FCC rules. Operation is subject to
									following two conditions (1), This
									device may not cause harmful inter-
									ferance, and (2) this device must
									accept any interferance received
									including interferance that may cause
									undesired operation.

RGB analog input terminals with composite or separate sync, or with sync on green. The projector detects automatically where the sync sig- nal is located.

Always use an interface when a computer and local monitor have to be connected to the projector. Examples of interfaces which can be applied :

RGBS or RGsB input selection

a. With the RCU: Select RGB in the Source Selection menu

Interface or VGA - RGB Cable

b. With the local keypad :

(to gain access to the local keypad, see ‘Local keypad’ in chap- ter “Location and function of controls’.)

-Press ADJUST key, the General access menu is displayed on the screen.

-Use the control disk to highlight 3.

-Press ENTER to select the highlighted source.

SOURCE SELECTION

SELECT AN INPUT FROM BELOW:

RGB

S-VIDEO

VIDEO COMPONENT VIDEO

Select with

or then <ENTER>

<EXIT> to return

FROM RCU

	GENERAL ACCESS
		SHARPNESS
		TINT
5	6	COLOR
3	4	BRIGHTNESS
1	2	CONTRAST

Enter ADJUST

Select with ,

or

then <ENTER>.

<EXIT> to return

FROM LOCAL KEYPAD

Connecting a RGB Analog source with Tri-level sync.

RS232 IN	RS232 OUT	IR	COMM PORT REMOTE	R	G(s)	B	H	V	VIDEO S - VIDEO This device complies with part 15 of
									the FCC rules. Operation is subject to
									following two conditions (1), This
									device may not cause harmful inter-
									ferance, and (2) this device must
									accept any interferance received
									including interferance that may cause
									undesired operation.

RGB analog input terminals with Tri level sync input or with Tri-level sync on green. The projector detects automatically where the sync signal is located.

RGB3S or RG3sB input selection VCR HDTV player

a. With the RCU: Select RGB in the Source Selection menu

b. With the local keypad :

(to gain access to the local keypad, see ‘Local keypad’ in chapter ‘Location and function of controls’.)

-Press ADJUST key, the General access menu is dis- played on the screen.

-Use the control disk to highlight 4.

-Press ENTER to select the highlighted source.

	GENERAL ACCESS
		SHARPNESS
		TINT
5	6	COLOR
3	4	BRIGHTNESS
1	2	CONTRAST

Enter ADJUST

Select with ,

or

then <ENTER>.

<EXIT> to return

FROM LOCAL KEYPAD

3-4