Runco VX-6000D Primary Lens Adjustments, Focus Zoom Iris Vertical and Horizontal Lens Shift

Installation

Lens zoom and focus are motorized adjustments that are adjustable using the Setup remote control (Figure 2-6). This allows you to adjust the focus and image size while at the screen for more accurate results. The remote control has a range of approximately

100 feet (30.5 meters) for long throw distances.

The IR receiver for the lens motor assembly is located on the projector behind the front Runco logo cover. Rotate the logo cover 90 degrees as shown to reveal the IR receiver opening.

1.With the IR receiver revealed on the front of the projector, press the VX6K button on the Setup remote control to display the Lens Control menu page.

2.Point the remote directly at the projector for maximum range.

3.To focus the projected image, press and hold the FCUS+ or FCUS- button.

To make the picture smaller (zoom out), press and hold the ZOOM- button. To enlarge the picture (zoom in), press and hold the ZOOM+ button.

Press the IRIS button repeatedly to select an optical aperture or iris size (large or small).

To change the projected image position, use a 3/16” hex driver to shift the lens in the desired direction; see Figure 3-20.The vertical lens shift control is at the top of the projector; the horizontal lens shift control is on the same side of the projector as the lamp compartment cover. (The tool will automatically center on top of the adjustment nut when inserted into the access hole.)

3.8

Primary Lens Adjustments

Focus

Zoom

Iris

Vertical and Horizontal Lens Shift

Runco VX-6000d Installation/Operation Manual 43