Sharp PG-D2510X appendix Turn the computer on Turn the power off

BP. 28

6. Select the Input mode

Press INPUT P/R to display the INPUT list. Use INPUT P/R to select the Input mode, and use O/Q to select the audio input terminal.

On the remote control

Shrinks

lower side.

Shrinks

upper side.

(When “Setup Guide” is set to “On”. See page 48.)

2 Follow the steps in the Setup Guide and adjust the focus, height (angle) and picture size.

3 After adjusting the focus, height (angle) and picture size, press ENTER to finish the Setup Guide.

BP. 26

5. Correct trapezoidal distortion

Correcting trapezoidal distortion using Keystone Correction.

After the projector turns on, the Setup Guide appears.

1

4. Adjust the projected image with the Setup Guide

Easy Start

On the	INPUT list		On the
projector	INPUT	Audio	projector
	1 COMPUTER1
On the remote	2 MONITOR OUT		On the remote
	S S-VIDEO
control			control

VVIDEO

BP. 29

7.Turn the computer on

8.Turn the power off

Press STANDBY/ON on the projector or STANDBY on the remote control, and then press the button again while the confirmation message is displayed to put the projector into Standby mode.

On-screen display

On the	On the remote
projector	control

BP. 25

17