Configuration | Section 3 |
|
|
Configure Your Wireless Security Settings
Due to the limitation of the
WARNING!
When first configuring your WE800G, it is recommended that you have an Ethernet cable connected to the WE800G. Performing the INITIAL configuration using a wireless connection is not secure and is not recommended.
After you have finished the initial configuration of the WE800G, your connection will be secure and you can safely use either a wired or wireless connection.
Wireless Security Setup
Follow these procedures to set up the security protocols for your Wireless Ethernet Bridge. The settings below indicate how to setup the strongest security settings available for the WE800G.
If the wireless network you are going to connect to uses different security settings, then you will need to match the wireless network’s security settings to ensure a proper connection.
1Select Control Panel > Device Security.
2In the Login User ID field, enter your USER ID. Create an ID that contains a multiple of
3In the Login Password field, enter your PASSWORD. Create a password that contains multiple of
4
5 Click APPLY.
6Once the settings have been accepted, click RESTART and log back into the Configuration Manager using your new User ID and Password.
7Select Profile 1 or 2 and navigate to the Basic tab.
8Enter the Network ID (SSID) to match the SSID of the wireless network (either Infrastructure or
WE800G |